MAINTENANCE SCHEDULE
Check:
INSPECT MUFFLER AND SPARK
ARRESTING SCREEN
Fuel mixture level . . . . Before each use
Bar lubrication . . . . . . . Before each use
Chain tension . . . . . . . Before each use
Chain sharpness . . . . . Before each use
For damaged parts . . . Before each use
For loose caps . . . . . . Before each use
For loose fasteners . . . Before each use
For loose parts . . . . . . Before each use
Inspect and Clean:
As the unit is used, carbon deposits build up
on the muffler and spark arresting screen,
and must be removedto avoidcreating afire
hazard or affecting engine performance.
Replacethespark arrestingscreen ifbreaks
occur.
Muffler Diffuser
Spark
Arresting
Screen
Muffler
Cover
Bar . . . . . . . . . . . . . . . . Before each use
Complete saw . . . . . . . After each use
Air filter . . . . . . . . . . . . . Every 5 hours*
Chain brake . . . . . . . . . Every 5 hours*
Spark arresting screen
and muffler . . . . . . . . . . Every 25 hours*
Replace spark plug . Yearly
Replace fuel filter . . . Yearly
Screws
Muffler
Body
Muffler
Cover
*
Hours of Operation --
Each hour of operation is approximately
2
tanks of fuel.
CLEANING THE SPARK ARREST-
ING SCREEN
Cleaning is required every 25 hours of op-
eration or annually, whichever comes first.
AIR FILTER
1.
2.
3.
Loosen and remove the 2 muffler cover
screws.
CAUTION: Do not clean filter in gasoline
or other flammable solvent to avoid creating
a fire hazard or producing harmful evapora-
tive emissions.
Remove the muffler cover (cover snaps
off muffler body).
Remove muffler diffuser and spark ar-
resting screen assembly. Notice the
orientation of these parts for reassem-
bling.
Cleaning the air filter:
A dirty air filter decreases the life and perfor-
mance of the engine andincreases fuelcon-
sumption and harmful emissions. Always
clean your air filter after 10 tanks of fuel or 5
hours of operation, whichever comes first.
Clean more frequently in dusty conditions.A
used air filter can never be completely
cleaned. It is advisable to replaceyour air fil-
ter withanew oneafter every 50hours ofop-
eration, or annually, whichever comes first.
4.
Clean the spark arresting screen with a
wirebrush.Replacescreenifbreaksare
found.
5.
6.
Replace any broken or cracked muffler
parts.
Reinstall diffuser and spark arresting
screen assembly with round holes fac-
ing up.
7.
Reinstall muffler cover and 2 screws.
Tighten securely.
1.
2.
3.
4.
Loosen 3 screws on cylinder cover.
CARBURETOR ADJUSTMENT
Remove cylinder cover.
Remove air filter.
WARNING:
The chain will be mov-
Cleantheair filter usinghotsoapywater.
Rinse with clean cool water. Air dry
completely before reinstalling.
Lightly oil air filter before installing to im-
ing during mostof this procedure. Wear your
protective equipment and observe all safety
precautions.Thechainmustnotmoveatidle
speed.
The carburetor has been carefully set at the
factory. Adjustments may be necessary if
you notice any of the following conditions:
S Chain moves at idle. See IDLE SPEED--T
adjusting procedure.
S Saw will not idle. See IDLE SPEED--T ad-
justing procedure.
5.
prove the efficiency of air filter.
Use
2--cycle
engine oil or motor oil (SAE 30).
Squeeze excess oil from filter.
Reinstall air filter.
6.
7.
Reinstall cylinder cover and 3 screws.
TIghten securely.
Cylinder Cover
Screws
Air Filter
Idle Speed--T
Allow engine to idle. If the chain moves, idle
istoofast. Iftheenginestalls,idleis tooslow.
Adjust speed until engine runs without chain
movement (idle too fast) or stalling (idle too
slow). Theidle speedscrew is located inthe
area above the primer bulb and is labeled T.
S Turn idle speed screw (T) clockwise to in-
crease engine speed.
Cylinder
Cover
S Turn idle speed screw (T) counterclock-
wise to decrease engine speed.
14
| Categories | Chainsaw Manuals, Poulan Chainsaw Manuals |
|---|---|
| Tags | Poulan 1950, Poulan 1975, Poulan 2050, Poulan 2050WT, Poulan 2055, Poulan 2075, Poulan 2150, Poulan 2150PR, Poulan 2155, Poulan 2175, Poulan 2350, Poulan 2375 |
| Model Year | 2006 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Poulan. Poulan US phone support. Wheeled (Mowers, Tractors, Tillers): 1-800-849-1297 Handheld (Chainsaws, Trimmers): 1-800-554-6723 , Chainsaw |
| Document File Type | |
| Publisher | poulan.com |
| Wikipedia's Page | Poulan |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)