FUELING & LUBRICATION
STARTING
WARNING: Remove fuel cap slowly
WARNING:
The chain must not
move when the engine runs at idle speed. If
the chain moves at idle speed refer to CAR-
when refueling.
FUELING ENGINE
BURETOR
ADJUSTMENT
within
this
This engine is certified to operate on unleaded
gasoline. Before operation, gasoline must be
mixed with a good quality 2-cycle air-cooled
engine oil. We recommend Poulan/WEED
EATER brand oil. If you do not use this oil, use
agoodquality2-cycleair-cooledoildesignedto
be mixed at a ratio of 40:1. A 40:1 ratio is
obtainedbymixing3.2oncesofoilwith1gallon
of unleadedgasoline. Included withthis saw is
a3.2ounce(95ml)container ofPoulan/WEED
EATER brand oil. Pour the entire contents of
this container into 1 gallon (4 liters) of gasoline
to achieve the proper fuel mixture. DO NOT
USE automotive or boat oil. These oils will
cause engine damage. When mixing fuel
follow the instructions printed on the container.
Always read and follow the safety rules listed
under HANDLE FUEL WITH CAUTION.
manual. Avoid contact with the muffler. A hot
muffler can cause serious burns.
To stop the engine move the ON/STOP
switch to the STOP position.
To start the engine holdthe saw firmly onthe
ground as illustrated. Make sure the chain is
free to turn without contacting any object.
Use only 15”--18” of rope per pull.
Hold saw firmly while pulling starter rope.
Starter rope handle
Left hand
on front
handle
BAR AND CHAIN LUBRICATION
The bar and chain require continuous lubrica-
tion. Lubrication is provided by the automatic
oiler system when the oil tank is kept filled.
Lack of oil will quickly ruin the bar and chain.
Too little oil will cause overheating shown by
smoke coming from the chain and/or discolor-
ation of the bar.
In freezing weather oil will thicken, making it
necessary to thin bar and chain oilwith asmall
amount (5 to 10%) of #1 Diesel Fuel or
kerosene. Bar and chain oil must be free
flowingfortheoilsystemtopumpenoughoilfor
adequate lubrication.
Right foot through rear handle
IMPORTANT POINTS TO REMEMBER
When pulling the starter rope, do not use the
full extent of the rope as this can cause the
rope to break. Do not let starter rope snap
back. Hold the handle and let the rope rewind
slowly.
For cold weather starting, start the unit at
FULL CHOKE; allow the engine to warm up
before squeezing the throttle trigger.
NOTE
:
Do not cut material with the choke/
fast idle lever at the FULL CHOKE position.
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
Genuine Poulan or Poulan PRO bar andchain
oilis recommendedto protectyour unitagainst
excessive wear from heat and friction. Poulan
or Poulan PRO oil resists high temperature
thinning. If Poulan or Poulan PRO bar and
chainoilisnotavailable,useagoodgradeSAE
S
S
MoveON/STOPswitchtotheONposition.
Pull the choke/fast idle lever out to the full
extent.
ON
30
oil.
S Never use waste oil for bar and chain lubri-
cation.
S Always stop the engine before removing the
ON/STOP
SWITCH
oil cap.
IMPORTANT
Experience indicates that alcohol--blended
fuels (called gasohol or using ethanol or meth-
anol) canattractmoisture whichleads tosepa-
ration and formation of acids during storage.
Acidic gas can damage the fuel system of an
engine while in storage. To avoid engine prob-
lems,thefuelsystemshouldbeemptiedbefore
storage for 30 days or longer. Drain the gas
tank, start the engine and let it run until the fuel
lines and carburetor are empty. Use fresh fuel
nextseason. SeeSTORAGE section for addi-
tional information.
STOP
CHOKE/FAST IDLE LEVER
(SIDE VIEW)
Choke/Fast
Idle Lever
OFF
FULL
S Press thethrottlelock withyour righthand.
Squeeze and hold the throttle trigger;
Press and hold the fast idle lock with your
forefinger; release the throttle trigger.
9
| Categories | Chainsaw Manuals, Poulan Pro Chainsaw Manuals |
|---|---|
| Tags | Poulan Pro 330, Poulan Pro 380 |
| Model Year | 2006 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Poulan Pro. Poulan Pro US phone support. Wheeled (Mowers, Tractors, Tillers, Snow Throwers): 1-800-849-1297, Handheld (Chainsaws, Trimmers, Blowers, Edgers): 1-800-554-6723, Chainsaw |
| Document File Type | |
| Publisher | poulanpro.com |
| Wikipedia's Page | Poulan |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
Tried to download poulan 330 china’s manual. Would not work. Need to see carburetor. Where to put gasket