GENERAL SAFETY PRECAUTIONS
teeth on one side of the bar first. Then turn the saw
Setting the raker clearance
over and file the remaining teeth from the other side.
•
•
Before setting the raker clearance the cutting teeth
should be newly sharpened.
We recommend that you adjust the raker clearance
every third time you sharpen the chain. NOTE! This
recommendation assumes that the length of the
cutting teeth is not reduced excessively.
To adjust the raker clearance you will need a flat file
and a raker gauge.
•
File all the teeth to the same length. When the length
of the cutting teeth is reduced to 4 mm (0.16") the
chain is worn out and should be replaced.
•
•
Place the gauge over the raker lip.
Place the file over the part of the lip that protrudes
through the gauge and file off the excess. The
clearance is correct when you no longer feel any
resistance as you draw the file over the gauge.
General advice on setting raker clearance
•
When you sharpen the cutting teeth you reduce the
raker clearance (=cutting depth). To maintain optimal
cutting performance you must file back the raker lip to
the recommended height.
Tensioning the chain
•
On a low-kickback cutting link the front edge of the
raker lip is rounded. It is very important that you
maintain this radius or bevel when you adjust the raker
clearance.
WARNING! A slack chain may jump off
and cause serious or even fatal injury.
!
•
•
•
The more you use a chain the longer it becomes. It is
therefore important to adjust the chain regularly to
take up the slack.
Check the chain tension every time you refuel.NOTE!
A new chain has a running-in period during which you
should check the tension more frequently.
•
We recommend that you use our raker gauge to
achieve the correct clearance and bevel on the raker
lip.
Tension the chain as tightly as possible, but not so
tight that you cannot pull it round freely by hand.
WARNING! The risk of kickback is
increased if the raker clearance is too
large!
!
12
– English
| Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
|---|---|
| Tags | Husqvarna 327P4, Husqvarna 327P5, Husqvarna X-Series |
| Model Year | 2008, 2009 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Husqvarna, Chainsaw |
| Document File Type | |
| Publisher | husqvarna.com |
| Wikipedia's Page | Husqvarna |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)