Note: Moving the Z-fitting higher decreases the
gap between the control bar and the handle; moving
it lower increases the gap.
3.
4.
Hook the spring to the adjuster link and slide the
spring cover over the adjuster link.
Check the adjustment; refer to Checking the Control
Cable.
Note: After extended use, the drive belt may wear
and lose its proper belt tension. If the drive belt
slips (continuously squeals) under a heavy load,
disconnect the spring from the adjustor link and
move the upper end of the spring to the hole that
is further from the pivot point in the control bar
(Figure 27). Then connect the spring to the adjustor
link and adjust the control cable.
Figure 25
1.
Control bar
2.
1/16-inch to 1/8-inch (2
mm to 3 mm) gap
Note: Ensure that a 1/16-inch to 1/8-inch (2 mm to 3
mm) gap exists between the control bar and the handle
(Figure 25).
Important: The control cable must contain some
slack when you disengage the control bar for the
rotor blades to stop properly.
Adjusting the Control Cable
1.
Slide up the spring cover and unhook the spring
from the adjuster link (Figure 26).
Figure 27
1.
Remove the upper end of
spring from this hole
3.
4.
Pivot point
2.
Insert the upper end of
spring into this hole
Upper end of spring
Note: The belt may slip (squeal) in wet conditions;
to dry out the drive system, start the rotor and run
it without a load for 30 seconds.
Figure 26
1.
Adjuster link
Z-fitting
3.
4.
Spring cover
2.
Unhook the spring here.
Note: You can pull up the adjuster link and cable to
make unhooking the spring easier.
2.
Move the Z-fitting to a higher or lower hole on the
adjuster link as needed to obtain the 1/16-inch to
1/8-inch
(2 mm to 3 mm) gap between the control
bar and the handle (Figure 25).
14
| Categories | Snow Blower Manuals, Toro Snow Blower |
|---|---|
| Tags | Toro 38567, Toro 38569, Toro CCR 6053 R Quick Clear |
| Model Number | 38567, 38569 |
| Model Year | 2011 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Serial Number | 311000001 - 311999999 |
| Product Name | Toro CCR 6053 R Quick Clear Snowthrower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Product Type | Snowthrower |
| Product Series | Quick-Clear, Snowthrower |
| Swath | 21 inch |
| Discharge | Single Stage |
| Engine Manufacturer | Toro |
| Engine Oil Type | 20 oz. (.6 L) 5w-30 synthetic or 5w-30 below 40F (4c) or 10w-30 above 0F (-20c) |
| Engine Motor Model # | 115-0667 |
| Engine Motor Size | 163cc |
| Engine Motor Type | 4 Cycle CARB3 |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)