Ariens Sno Thro 932036 524 932037 724 932504 524 932505 724 Snow Blower Owners Manual

ATTACHMENT DRIVE BELT
REPLACEMENT
7
4
Remove Attachment Drive Belt
(Figures 16 and 17)
3
5
6
1.
Shut off engine, remove key, disconnect
spark plug wire and allow unit to cool
completely.
2.
3.
4.
Remove two screws securing belt cover
to unit and remove belt cover.
Remove spring pin from chute crank rod
assembly and separate.
Remove hardware holding chute strap to
engine and lift discharge chute off
housing.
5.
6.
Remove belt nger by removing cap
screws mounting belt nger to engine
(Figure 17).
Remove attachment drive belt from
engine sheave (it may be necessary to
turn engine sheave using recoil starter
handle).
1
2
8
1.
Housing Bolt
Holes
Belt Cover
5. Chute Crank
6. Chute Strap
7. Chute Strap
Mounting
Hardware
Bottom Cover
CAUTION: Always support
Sno-Thro frame and housing when
loosening the cap screws holding
them together. Never loosen cap
screws while unit is in service
position.
2.
3.
4.
Pinion and Gear
Spring Clip Pin
8.
Figure 16
OS0803
IMPORTANT: To avoid bending bottom cover,
when tipping unit apart, support handlebars
rmly or tip unit up on housing and remove
bottom cover by removing four cap screws
before separating unit.
Replace Attachment Drive Belt
1. Place new belt onto lower pulley and
while holding brake out of way, tip unit
together.
7.
8.
Support Sno-Thro frame and housing.
2. Secure blower housing to frame with cap
screws.
Remove top two cap screws and loosen
lower cap screws holding blower housing
to frame (one on each side).
Separate housing from unit. Lower
handlebar on oor.
3. Place belt onto engine sheave.
4. Make sure engine sheave and attachment
pulley align. If alignment is necessary,
loosen engine sheave set screws,
reposition sheave and retighten set
screws.
9.
10.
Remove attachment drive belt from lower
pulley (hold brake away from belt).
5.
Replace belt nger.
IMPORTANT: BELT FINGER MUST BE
between 1/16 to 1/8 in. (1.63 mm) from belt
with attachment clutch engaged or belt
grabbing may occur causing impeller to rotate
while attachment clutch is disengaged
(Figure 17).
6.
7.
8.
9.
Adjust clutch per Attachment Clutch/
Impeller Brake Adjustment below.
Reinstall chute strap and mounting
hardware onto engine.
Replace chute crank and secure with
spring pin.
Replace belt cover and secure with cap
screws.
GB - 22
Product Specification
CategoriesAriens Snow Blower Manuals, Snow Blower Manuals
Tags, , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 31 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandAriens, Snow Blower
Document File TypePDF
Publisherariens.com
Wikipedia's PageAriens
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website