3.
Ensure Z bend end of clutch cable is
connected to hole in tab on right side of
clutch bail.
Check Function of All Controls
Ensure unit runs and performs properly. Refer
to Operation Section.
Check Auger Gearcase Oil
Check oil level in auger gearcase (see
Maintenance Section).
Run in Attachment Belt
1.
Start unit in a well-ventilated area
according to Starting and Shut-Off in
Operation.
Fill Engine Crankcase
2.
3.
4.
Engage attachment clutch lever and run
attachment for about 15 minutes.
Stop unit, wait for all moving parts to stop,
and remove spark plug wire.
Adjust clutch according to Attachment
Clutch/Brake Adjustment in Service and
Adjustments.
IMPORTANT: Engines are shipped without oil
in crankcase. Refer to Engine Manual for
proper type oil and crankcase capacity.
Fill Engine Fuel Tank
Refer to Engine Manual for proper type and
capacity.
OPERATION
Ignition Switch
Key Switch has two positions:
WARNING: AVOID INJURY. Read
and understand Operational and Fuel
Safety Rules before proceeding.
1.
2.
NOTE: DO NOT twist key after
inserting it.
"Stop" - Pulled Out
Run - Pushed In
2
1
CONTROLS AND FEATURES
See Figure 1 for all Controls and Features.
Primer Bulb
Discharge Chute Deflector
ALWAYS position discharge chute deflector at
a safe angle before starting engine.
Pushing the Primer Bulb in adds
fuel for easier engine start (see
Starting and Shut Off).
DO NOT throw snow any higher than
necessary.
Push deflector handle forward or down to
throw snow lower. Pull deflector handle up or
to the rear to throw snow higher.
IMPORTANT: If Chute Deflector does not stay
in set position, adjust as directed in Service
and Adjustments, or repair before operation.
OS1321
Choke Control Knob
1. Choke Closed position:
Choke Control chokes off air
to engine for easier start.
2. Choke Open position:
allows for normal operation.
2
1
Discharge Chute
Discharge chute rotates 220°.
ALWAYS position discharge chute in safe
direction and angle, away from operator and
bystanders, before starting engine.
IMPORTANT: Gradually
open choke after engine
starts.
OS1300
Scraper Blade
The scraper blade allows the back of the
housing to keep better contact with the surface
being cleared. It also prevents damage to the
housing from normal wear.
IMPORTANT: DO NOT allow Scraper Blade to
wear too far or Auger/Impeller housing will
become damaged.
Chute Crank (932103, 310)
IMPORTANT: If chute does not stay in set
position, adjust as directed in Service and
Adjustments, or repair before operation.
Rotate the Chute with Discharge Chute Crank
Handle.
IMPORTANT: DO NOT force frozen chute
controls. Start engine and run for 3-5 minutes
to thaw. If still frozen, take to warm place until
controls are free.
GB - 13
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 520, Ariens 624, Ariens 932102, Ariens 932103, Ariens 932310 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)