4.
Check spring length.
a.Measure the length of the clutch cable
spring.
b.Engage and hold the attachment
clutch bail.
c.Measure the length of the spring
again. The spring should be
1/8-3/16
in (3-5 mm) longer when the
bail is engaged.
Cap Screws
5. Adjust spring length.
a.Loosen the idler adjustment nut.
b.To increase spring extension, move
idler towards belt (Figure 7).
Figure 8
OS1881
c.To decrease spring extension, move
idler away from belt.
d.Tighten idler adjustment nut.
ATTACHMENT CLUTCH / BRAKE
ADJUSTMENT
6.
7.
Check brake.
When the clutch bail is disengaged, the
brake must contact attachment belt.
When the clutch bail is engaged, the
brake must be more than 1/16 in (1.6 mm)
away from the belt.
WARNING: IMPROPER
ADJUSTMENT could result in
unexpected movement of auger
and impeller causing death or
serious injury. Auger/impeller must
stop within 3 seconds when
attachment clutch bail is released.
Repeat steps 4 – 6 until:
Spring stretch and brake contact are
correct.
IMPORTANT: If attachment clutch/brake
cannot be adjusted within tolerances, see your
Dealer for repairs.
1.
2.
Remove belt cover.
Check belt alignment (Figure 9).
Engine sheave and attachment pulley
must align vertically. Also, belt must be
centered in the idler pulley.
8. Check belt finger clearance.
To move pulley or sheave:
a.Loosen set screw.
b.Slide pulley/sheave and key to desired
position.
c.Tighten set screw.
Adjust cable slack.
With clutch bail engaged, belt fingers
should be 1/16 – 1/8 in (1.6–3 mm) from
belt. Adjust belt fingers as necessary.
Replace belt cover.
Check that auger/impeller stops within
9.
10.
3
impeller brake bail is released.
seconds after attachment clutch/
3.
IMPORTANT: The clutch cable must be slack
when the bail is disengaged.
a.With clutch bail disengaged, loosen
jam nut on cable adjuster.
b.Lift spring arm, but do not move idler
arm.
c.Turn adjuster body to remove all slack
from the cable. Do not stretch spring
or move idler arm.
d.Release spring arm and turn back the
adjuster body 5 turns (approximately
1/4
in or 6 mm). Finger tighten jam nut.
e.Hold adjuster body with pliers and
tighten jam nut with wrench.
GB - 19
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 520, Ariens 624, Ariens 932102, Ariens 932103, Ariens 932310 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)