Throttle
PRE-START
The Throttle controls the engine
speed. To increase or decrease
the engine speed, adjust to:
1.Fast (normal or warm starts)
2.Part-Throttle
1.
IMPORTANT: Before starting engine, check
impeller to be sure it is not frozen.
Frozen Impeller
1
2
1.
With key in “Stop” position, squeeze
attachment clutch lever to engaged
position.
3.Slow
4."Stop"
(cold weather starts)
(engine is off)
3
2. Pull recoil starter handle.
4
OL2072
IMPORTANT: If impeller is frozen, (cannot pull
starter handle) move unit to a heated area and
thaw to prevent possible damage.
STOP
Recoil Starter Handle
IMPORTANT: DO NOT let handle snap back
against starter.
2.
Check Function of Clutch
Auger and impeller must stop quickly when
attachment clutch bail is released.
If clutch does not engage or disengage
properly, adjust or repair before operation (see
Service and Adjustments).
When pulled, handle will turn engine over.
Auger
The auger propels unit forward while collecting
snow. Forward speeds may vary according to
depth and moisture content.
3.
Check Engine Fuel & Crankcase Oil
Attachment Clutch Bail
WARNING: AVOID INJURY. Read
and understand Fuel Safety Rules in
Safety section before proceeding.
Squeeze the attachment clutch bail against
the handlebar to engage auger and impeller.
Release bail to disengage and brake auger
and impeller.
Check and add fuel if required. If oil is not up
to “FULL” mark on dipstick, add recommended
oil.
FILLING FUEL TANK
See Engine Manual for detailed instructions.
WARNING: AVOID INJURY. Read
and understand Fuel Safety Rules in
Safety section before proceeding.
STARTING AND SHUT-OFF
WARNING: FAILURE TO FOLLOW
INSTRUCTIONS could result in
To add fuel to fuel tank:
1.
ALWAYS place unit in open or well
ventilated area.
Stop engine and allow to cool.
Clean Fuel Cap and surrounding area to
prevent dirt from entering Fuel Tank.
Remove Cap.
personal injury and or damage to unit.
DO NOT attempt to start your unit at
this time.Read entire Owner/Operator
Manual and the Engine Manual first.
2.
3.
IMPORTANT: Allow unit and engine to adjust
to the outdoor temperatures before clearing
snow. Before shut-off, run the attachment a
few minutes to prevent freeze-up.
NOTE: Try out each control without the engine
running to see how it works and what it does.
4.
IMPORTANT: DO NOT use gasohol or
gasoline containing alcohol. See Engine
Manual for correct type and grade of fuel.
5.
Fill fuel tank to within 1/2 in (1.2 cm)
below bottom of filler neck with unleaded
gasoline.
Manual Start
Turn discharge chute straight ahead.
Release auger clutch bail.
3. Push Primer Bulb 2 or 3 times for a cold
engine.
1.
2.
NOTE: Tank capacity for 932103 and 310 is
quarts (3.3 liters). Tank capacity for
is 2.0 quarts (1.9 liters).
Replace Fuel Cap and tighten.
3.5
932102
6.
IMPORTANT: ALWAYS clean up any spilled
fuel.
NOTE: When temperature is below
-15˚F (-26˚C) additional priming may be
needed.
4.
If engine is cold, apply choke. See Engine
Manual for detailed instructions.
NOTE: A warm engine requires less choking
than a cold engine.
GB - 14
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 520, Ariens 624, Ariens 932102, Ariens 932103, Ariens 932310 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)