IMPORTANT: DO NOT operate starter more
than 15 seconds per minute, as overheating
and damage can occur. (If engine does not
start, refer to Troubleshooting.)
IMPORTANT: DO NOT overload unit capacity
by attempting to clear snow at too fast a rate.
Use slow speed to clear deep or hard packed
snow.
10. Adjust choke as needed.
Tips for Operation
11. Disconnect power cord from outlet, then
starter.
Snow is best removed as soon as possible
after snow fall.
12. Set throttle to Part Throttle or Slow
position for travel or adaptation to outside
temperature. Once achieved, set throttle
to Fast position for normal operation.
To clear an area, run unit in an overlapping
series of paths. For large areas; start in the
middle and throw snow to each side, so snow
is not cleared more than once.
Shut Off
ALWAYS direct snow away from area to be
cleared and with direction of the wind.
1. Release Traction Drive Clutch Lever and
allow unit to come to a complete stop.
TRAVELING
2. Run Impeller a few minutes after use to
prevent freeze-up of Impeller.
To travel from one work area to another:
1. Set Throttle to Slow or Part-Throttle
position.
3. Release Attachment Clutch Lever and wait
for all moving parts to come to a complete
stop.
2. Press down on handlebars enough to
raise front of unit slightly off surface.
4. Move Throttle to the “Stop” position.
5. Remove key.
3. Engage wheel drive clutch without
engaging attachment drive clutch.
SNOW REMOVAL
TRANSPORT
IMPORTANT: Allow unit and engine to adjust
to the outdoor temperatures before clearing
snow.
NOTE: Attachment clutch should be engaged
before wheel drive clutch when throwing snow.
1. Select Speed Control position and
direction.
ALWAYS shut off engine, remove key, and
close fuel shut-off valve when transporting unit
on a truck or trailer.
Use extra care when loading or unloading unit
onto trailer or truck.
Secure unit chassis to transport vehicle.
NEVER secure from rods or linkages that
could be damaged.
2. Engage Attachment Clutch - Right Hand
Lever.
3. Engage Traction Drive Clutch - Left Hand
Lever.
DO NOT transport machine while engine is
running.
MAINTENANCE
Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine manufacturer's
service center.
SERVICE POSITION
WARNING: Before tipping unit up
onto housing, remove fuel so no
spills will occur. Ensure unit is
secure and will not tip over during
maintenance.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Place unit on a flat level surface. Tip unit
forward onto front of impeller housing for
service. Assure unit is secure and will not tip
over. Strap and clamp onto bench if needed.
MAINTENANCE SCHEDULE
The chart below shows the recommended
maintenance schedule that should be
performed on a regular basis. More frequent
service may be required.
GB - 17
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932105-8526, Ariens 932506-8526 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)