6. Adjust clutch per
Clutch/Impeller Brake Adjustment below.
Attachment
2. Pull idler away from traction drive belt and
remove belt from idler, camshaft pulley
and driven pulley (it may be necessary to
turn camshaft pulley using recoil starter
handle).
7. Replace chute crank and secure with
spring pin.
8. Replace belt cover and secure with
screws.
NOTE: To gain clearance, engage traction
clutch and if necessary pull back attachment
brake/idler arm.
3
2
3. Replace traction drive belt.
4
4. Replace attachment drive belt (See
Replace Attachment Drive Belt).
1
ATTACHMENT CLUTCH/BRAKE
ADJUSTMENT
WARNING: IMPROPER
ADJUSTMENT could result in
unexpected movement of auger and
impeller causing death or serious
injury. Auger / impeller must stop
within 3 seconds when Attachment
Clutch/Impeller Brake lever is
released.
5
8
WARNING: Adjustment procedure
requires the engine to be run with
the belt cover off. Read, understand
and follow all Operational, Fuel and
Maintenance and Service Safety
Rules before adjusting your unit.
7
6
1.
2.
3.
Belt Finger
Attachment Drive Belt
Traction Drive Belt
4
5
6.
7
8.
. Camshaft Pulley
. Traction Belt Idler
Engine Sheave
. Attachment Pulley
Attachment Belt Idler
1. Remove belt cover.
2. Adjust cable slack (Figure 19).
IMPORTANT: The clutch cable must be slack
when lever is disengaged.
a.With clutch lever disengaged, loosen
jam nut on cable adjuster.
Figure 18
OS6810
b.Turn adjuster body to remove all slack
from the cable. Do not stretch spring
or move lower clutch arm.
TRACTION DRIVE BELT
REPLACEMENT
c.Finger tighten the jam nut and then
turn back the adjuster body 2 turns.
NOTE: Housing and frame must be tipped
apart and attachment drive belt removed from
engine sheave in order to change traction
drive belt (Figures 17 & 18).
d.Hold adjuster body with pliers and
tighten jam nut with wrench.
3. Check spring length.
a.Measure the length of the clutch cable
spring.
CAUTION: Always support
Sno-Thro frame and blower housing
when loosening the cap screws
holding them together. Never loosen
cap screws while unit is in service
position.
b.Engage and hold the attachment
clutch lever.
c.Measure the length of the spring
again. The spring should be
1. Remove attachment drive belt (See
Remove Attachment Drive Belt).
3/16
–3/8 in. (4.7–9.5 mm) longer
when the lever is engaged.
GB - 23
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932105-8526, Ariens 932506-8526 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)