CHECK ENGINE OIL
MAINTENANCE
SCHEDULE
The engine crankcase oil should be checked
every 5 hours of operation. Oil level MUST be
maintained in safe operating range on dipstick
at all times or engine damage will result (See
Engine Manual).
Service
Each Every Every Yearly
Performed
Use
5 hrs.
25
hrs.
Park unit on a level surface. Refer to Engine
Manual for detailed instructions.
Check Dual
Handle
•
Interlock
CHANGE ENGINE OIL
Check
•
•
•
Change oil after first 2 hours of operation,
thereafter change oil every 25 hours (more
often if required). Refer to Engine Manual for
detailed instructions.
Fasteners
Check
Clutches
Run engine just prior to changing oil. Warm oil
will flow more freely and carry away more
contamination. Remove the oil drain plug from
the rear of the unit and tip the unit back to help
drain all the oil.
Clean Engine
Check Engine
Oil
•
Change
Engine Oil
*
•
•
•
•
CHECK TIRE PRESSURE
Check Tire
Pressure
Keep tires at pressure listed on the tire
sidewall.
Check Auger
Gearcase
•
•
CHECK AUGER GEARCASE
IMPORTANT: Proper oil level must be
maintained.
General
Lubrication
Gear cases are filled to the correct level at the
factory. Unless there is evidence of leakage,
no additional lubricant should be required.
Check oil level each season or every 25 hours
of operation.
*
After first two hours of operation.
CHECK DUAL HANDLE
INTERLOCK
To ensure adequate lubricant level:
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches must
disengage.
1. Remove filler plug (Figure 10). Lubricant
must be at least up to bottom of lubricant
filler hole with unit resting on a
level-surface.
2. Add lubricant if required. Allow oil to drain
to level of plug and replace plug.
CHECK FASTENERS
IMPORTANT: Use only Ariens special gear
lubricant L-2 (Part Number 00008000).
Make sure all hardware is tightened properly.
CHECK CLUTCHES
1
Auger / impeller must stop within 3 seconds
when attachment clutch/impeller brake lever is
released.
2
Wheels must stop quickly when traction drive
clutch lever is released.
If clutches do not engage or disengage
properly, adjust or repair before operation (see
Service and Adjustments).
1.
2.
Auger Gearcase
Filler Plug
CLEAN ENGINE
Figure 10
OS6775
Refer to Engine Manual for detailed
instructions.
GB - 18
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 932105-8526, Ariens 932506-8526 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)