MAINTENANCE
hYdRaULiC FLUid and inLet FiLt eR
•
Check the hydraulic fluid level in the log splitter reservoir tank
before each use. Maintain fluid level within the range specified on
the dipstick at all times.
•
Change the hydraulic fluid in the reservoir every 100 hours of
operation. Follow the steps below:
1.
2.
Disconnect the suction hose from the bottom of the reservoir tank.
Carefully unthread the inlet filter and clean it with penetrating oil.
See Figure 5-2.
3.
4.
Allow the fluid to drain into a suitable container.
Reinsert the filter and refill the reservoir with three (3) gallons of
oil. Approved fluids include Dexron® III / Mercon® III automatic
transmission fluid, a 10 Weight AW hydraulic oil or Pro-Mix™
AW-32 Hydraulic Oil.
•
Maintain fluid level within the range specified on the dipstick at all
times.
Figure -
NOTE: Always dispose of used hydraulic fluid and engine oil at
enGine
approved recycling centers only.
Check engine Oil
1. Stop engine and wait several minutes before checking oil level.
•
Contaminants in fluid may damage the hydraulic components.
Flushing the reservoir tank and hoses with kerosene whenever
service is performed on the tank, hydraulic pump or valve is
recommended. Any repair to the hydraulic components should be
performed by a Sears Service Center.
2.
3.
Remove oil fill dipstick.
Check oil level on dipstick. With engine on level ground, the oil
must be to FULL mark on dipstick.
Replace dipstick and tighten.
WaRninG
4.
Use extreme caUtion when working with kerosene. it is an extremely
Changing engine Oil
flammable flUid.
Only use high quality detergent oil rated with API service classification
SF, SG, or SH. Select the oil’s SAE viscosity grade according to the
expected operating temperature. Follow the chart below:
hydraulic Filter
•
C10hamicronnge thehydraulichydraulifilter.c filterOrdereverypart50 hnumberours of 723-0405.operation. Use only a
beaM and SPLit t inG WedGe
Colder
Warmer
•
•
Lubricate both sides of the beam (where it comes into contact with
the splitting wedge), before each use, with engine oil. The wedge
plate on the log splitter is designed so the gibs on the side of the
wedge plate can be removed and rotated and/or turned over for
even wear.
Make certain to readjust the adjustment bolts so wedge moves
freely, but no excess space exists between the wedge plate and the
beam.
SAE 30
5W30
Oil Viscosity Chart
1
| Categories | Craftsman Lawn Mower Manuals, Lawn Mower Manual |
|---|---|
| Tags | Craftsman 247.77614, Craftsman 675 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Craftsman. Customer Service Representatives are available by phone: Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | craftsman.com |
| Wikipedia's Page | Craftsman (tools) |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)