ASSEMBLY
2.
3.
4.
5.
Disconnectthe six hex screws.the dislodgerSee Figurefrom the3-4.beam weld bracket by removing
Disconnect the log cradle from the beam on the side of the control
valve. See Figure 3-5.
Liftbrackets.and slide the cylinder up to the top of beam and into the weld
Attachhardware,the previouslydislodger overremoved,the wedgeto theassemblyweld brackets.and secure with
NOTE: Once the six hex screws are tightened, there may be a slight
gap between the dislodger and the weld brackets. This gap is normal.
6.
Reattach the log cradle to the side of the beam with the control
valve, aligning the ends of the cradle with the beam flanges.
7.
Roll log splitter off the bottom crate.
Figure -
PRePaRinG t he LOG SPLit t eR
1.
Lubricate the beam area (where the splitting wedge will slide) with
engine oil; do not use grease.
2.
Removeengine onventedtop ofreservoirthe reservoirdipstick,tank.whichSee Figureis located3-6.in front of the
IMPORTANT: The log splitter may have been shipped and primed
with hydraulic fluid in the reservoir tank. However, you MUST check
the fluid level before operating. If not filled, proceed with the following
steps:
3.
Fill the reservoir tank with hydraulic fluid included with this unit (if
equipped) or approved fluids which include Dexron® III / Mercon®
III automatic transmission fluid, a 10 Weight AW hydraulic oil or
Pro-Mix™ AW-32 Hydraulic Oil.
4.
5.
Check fluid level using the dipstick. See Figure 3-6. Do not overfill.
Replace vented dipstick securely, tightening it until the top of the
threads are flush with top of the pipe.
Figure -
6.
7.
Disconnectstarter as fartheassparkit will pluggo. Repeatand primeapproximatelythe pump by10pullingtimes. the recoil
Reconnect the spark plug wire and start engine following instruc-
tions in the OPERATION section.
8.
9.
Useposition.controlThenhandleretractto theengagewedge.the wedge to the farthest extended
Refill tank as specified on the dipstick.
NOTE: Failure to refill the tank will void unit’s warranty.
10.
Extend and retract the wedge 12 complete cycles to remove
trapped air in the system (the system is “self-bleeding”).
11.
Refill reservoir within range marked on the dipstick.
WaRninG
Much of the original fluid has been drawn into the cylinder and hoses.
Make certain to refill the reservoir to prevent damage to the hydraulic
pump.
Figure -
NOTE: Some fluid may overflow from the vent plug as the system
builds heat and the fluid expands and seeks a balanced level.
| Categories | Craftsman Lawn Mower Manuals, Lawn Mower Manual |
|---|---|
| Tags | Craftsman 247.77614, Craftsman 675 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Craftsman. Customer Service Representatives are available by phone: Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | craftsman.com |
| Wikipedia's Page | Craftsman (tools) |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)