PREPARING VEHICLE
Install J-Bracket on Lift Lever
NOTE: If one hole in tractor frame, drill second hole (D)
using sway bar bracket (B) as a template.
E
A
C
B
C
D
B
M63885A
M63882
1.
with long end to the outside as shown.
Install J-bracket (A) 250 mm (10 in.) from top of lever (B)
a. Install M8 clamp-on nut and M8 x 25 bolt (C) in first
hole.
2.
Tighten nut.
Fasten bracket with M8 carriage bolt (C) and lock nut.
b. Move sway bar bracket so that it is flush with edge
(E) of tractor frame. Tighten bolt (C).
c. Drill hole (D) into tractor frame using second hole of
bracket as template.
Install Sway Bar Bracket
d. Loosen bolt (C) and install M8 clamp-on nut and
M8 x 25 bolt into drilled hole and bracket. Tighten both
bolts.
A
Install Reflective Tape
C
B
M63882a
1.
Slide two M8 clamp-on nuts (A) over holes on right-front
side of tractor frame.
A
2.
Align holes in sway bar bracket (B) with holes in bottom
of frame and fasten with two M8 x 25 bolts (C). Tighten
bolts.
M63893A
3.
tractor frame.
Follow next procedure if there is only ONE hole in the
Apply reflective tape (A) to rear bumper of units without
reflectors.
Preparing Vehicle - 6
| Categories | John Deere Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | John Deere 141984 I9, John Deere 42 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | John Deere, Snow Blower |
| Document File Type | |
| Publisher | deere.com |
| Wikipedia's Page | John Deere |
| Copyright | Attribution Non-commercial |
(4 votes, average: 4 out of 5)
Lawn and Garden readers have rated John Deere 141984 I9 42-Inch Snow Blower Owners Manual 4.0 out of 5.0 based on 4 product reviews. good book very helpful for what I was looking for.