Off-Season Storage
•
•
•
Remove all debris from the exterior of equipment.
Follow lubrication recommendations on page 11.
Always store the snow thrower in a clean, dry area.
WARNING: Never store engine with fuel in
NOTE: When storing any type of power equipment in an
unventilated or metal storage shed, care should be
taken to rustproof the equipment. Using a light oil or
silicone, coat the equipment, especially any chains,
springs, bearings and cables.
tank indoors or in poorly ventilated areas,
where fuel fumes may reach an open flame,
spark or pilot light as on a furnace, water
heater, clothes dryer or other gas appliance.
•
If unit is to be stored over 30 days, prepare engine
for storage as instructed in the engine manual.
SECTION 8: TROUBLESHOOTING
Problem
Possible Cause
Remedy
Engine fails to start
1. Fuel tank empty, or stale fuel.
1. Fill tank with fresh gasoline.
2. Clean the fuel line.
2.
3.
4.
5.
6.
Blocked fuel line.
Choke not ON.
Faulty spark plug.
Key not in ignition switch.
Spark plug wire disconnected.
3. Turn Choke knob to ON position.
4. Clean, adjust or replace spark plug.
5. Insert the key fully; do not turn.
6. Attach spark plug wire to the spark
plug on the engine.
7.
Primer not used properly.
7. Prime the engine as instructed earlier.
If the carburetor is flooded due to
over-priming, wait till it dries out.
Engine runs erratic
1. Unit running at FULL choke.
1. Turn choke knob to OFF position.
2. Clean the fuel line, fill tank with fresh
gasoline.
2.
Blocked fuel line or stale gasoline.
3.
Water or dirt in fuel system.
3. Drain fuel tank and carburetor. Fill up
with fresh gasoline.
Engine loses power 1. Spark plug wire loose.
1. Connect spark plug wire.
2.
Gas cap vent hole plugged.
2. Remove ice and snow from gas cap.
Be certain that vent hole is clear.
Excessive vibration
1. Loose parts or damaged auger.
1. Stop the engine immediately and
disconnect spark plug wire. Tighten all
bolts and nuts. If vibration continues,
contact service center.
Unit fails to propel
itself
1. Drive belt loose or damaged.
1. Chute assembly clogged.
1. Replace drive belt.
Unit fails to
discharge snow
1. Stop engine and disconnect spark
plug wire. Clean chute and inside of
auger housing with clean-out tool or
stick.
2.
3.
Shear pin sheared.
Foreign object lodged in auger.
2. Replace shear pin.
3. Stop engine immediately and
disconnect the spark plug wire.
Remove object from auger.
4.
5.
Auger control cable out of adjustment.
Auger belt loose or damaged.
4. Adjust auger control cable.
5. Replace auger belt.
Augers continue to
rotate
1. Cable out of adjustment.
1. Adjust auger control cable as shown
in “Making Adjustments” on page 10.
NOTE: For repairs beyond minor adjustments listed above, contact an authorized service dealer.
14
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | MTD 3BA, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)