SECTION 3: KNOW YOUR SNOW THROWER
WARNING: Be familiar with all the controls on the snow thrower and their proper operation. Know how to
stop the machine and disengage them quickly.
•
Compare Figure 6 with your equipment and follow description of controls, given below, to get familiar with
their operation.
Auger Control
Upper Handle
Drive Control
Oil Fill/
Starter Rope
Dipstick
Muffler
Gas
Cap
Gas Cap
Spark
Plug
Carburetor
Chute Handle
Upper
Chute
Electric
Starter
Chute Knob
Button
(If Equipped)
Chute
S
T
O
P
Assembly
Recoil
Starter
Choke
Shave
Plate
Ignition
Key
Clean-Out Tool
Primer
Oil Drain
Skid Shoe
Auger
Throttle Control
Figure 6
Throttle Control
Chute Handle
The direction of snow throwing corresponds to the
direction of the chute opening. Use the chute handle to
turn the chute assembly in the direction you wish to
throw the snow.
The throttle control is located on the engine. It regulates
the speed of the engine and also stops the engine.
Drive Control
Located on the underside of the upper handle, the drive
control is used to engage/disengage wheels. Squeeze the
drive control against the upper handle to engage the wheels;
release to disengage.
Chute Knob
The distance snow is thrown can be adjusted by either
raising or lowering the upper chute. Loosen the chute
knob on the side of the upper chute to adjust. Pivot the
upper chute to desired position, and retighten the chute
knob.
Auger Control
The auger control is adjacent to the upper handle.
Squeeze the auger control against the upper handle to
engage the augers; release to disengage the augers.
Ignition Key
The ignition key is necessary for the engine to start.
Insert key and snap in place; do not turn it to start/stop
the unit. Remove key when the unit is not in use.
WARNING: Nevermakeadjustmentstothe
chute assembly unless both auger and drive
controlsaredisengagedandtheoperatoris
standing beside the unit.
Skid Shoe
The space between the shave plate and the ground can
be adjusted. For close snow removal, place skid shoes
in the low position. Use middle or high position when
area to be cleared is uneven or on gravel surfaces.
IMPORTANT: Refer to Auger Control Test on page 9
prior to operating your snow thrower. Read and follow
all instructions carefully and perform all adjustments to
verify your snow thrower is operating safely and
properly.
7
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | MTD 3BA, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)