MTD 3BA Snow Blower Owners Manual

SECTION 2:  ASSEMBLING YOUR SNOW THROWER
IMPORTANT: This unit is shipped with the engine full of
oil. After assembly, see page 8 for fuel and oil details.
Handle
Knob
Saddle
Washer
Removing From Carton
Cut the corners of the carton and lay the sides flat
on the ground. Remove all packing inserts.
Move the snow thrower out of the carton.
Make certain the carton has been completely
emptied before discarding it.
Handle Tab
Hex Bolt
Before Assembly
Figure 2
NOTE: Reference to right, left, front or rear of the unit is
from the operating position unless otherwise stated.
Hold both controls against the upper handle and
pull up as shown in Figure 3. Make sure that the
upper handle locks over the lower handle and the
handle tabs align with the handle. You may have to
carefully maneuver the upper handle to clear the
chute assembly.
Cut the cable tie that secures the upper handle to
the chute assembly for shipping purposes.
Setting Up The Handle
CAUTION: Be careful not to bend or kink the cables.
Loosen the chute knob on the upper chute and
pivot the upper chute upwards as far as it will go.
Follow the direction of the arrow in Figure 1.
Final position of
Upper Handle
Upper Chute
Initial position of
Upper Handle
Chute Handle*
Chute Knob
* Meant only to rotate the chute
Figure 3
Figure 1
Tighten the handle knobs on each side of the
handle. Refer to Figure 2.
Rotate the chute by the chute handle to the desired
operating position.
Tighten the chute knob on the upper chute making
sure the flat washer and the carriage bolt are
correctly positioned. Refer to Figure 1.
WARNING: Do not lift the snow thrower by
the chute handle.
Loosen the handle knob, saddle washer and
handle tab on each side of the handle. See Figure
2.
Clean-Out Tool
This tool and the electric extension cord, if so equipped,
may be fastened with a cable tie to the rear of the auger
housing for shipping purposes. In that case, cut the
cable tie and remove the extension cord now.
5
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 20 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website