7
Service
Replacing Belt
To replace the belt follow these instructions and refer to Fig. 7-2:
1
2
.
.
Push down on the Idler pulley.
1
.
Remove the belt cover by removing five hex screws. See
Fig. 7-1.
Position the belt on top of the auger pulley, under the belt
keeper.
2
.
Remove the belt by grasping it from the bottom of the
auger pulley and pulling outward.
3
.
Route the belt around the engine pulley.
Push the belt over the bottom of the auger pulley.
Reinstall the belt cover removed earlier.
NOTE: Push down on the idler puller to release the belt
from under the belt keeper. See Fig. 7-1.
4.
5
.
Idler pulley
Belt Keeper
Auger Pulley
Engine Pulley
Figure -1
Figure -
1
Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
---|---|
Tags | MTD 769-01283C, MTD Snow Blower Manual |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | MTD, Snow Blower |
Document File Type | |
Publisher | mtdproducts.com |
Wikipedia's Page | MTD Products |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)