MTD 769-01283C Snow Blower Owners Manual

3
Assembly & Set-Up
Contents of Carton
Two Ignition Keys
One 2.6 oz. Bottle of Two Cycle Oil
One Extension Cord (if equipped)
One Snow Thrower Operator’s
Manual
One Tecumseh Engine Operator’s
Manual
One Product Registration  Card
NOTE: This Operator’s Manual covers several models.  Snow
thrower features may vary by model.  Not all features in this
manual are applicable to all snow thrower models.
Assembly
Positioning the Upper Handle
1
.
Making sure not to pinch the cable in the  process, pivot the
upper handle into the operating position  as illustrated in
Fig. 3-1 until it clicks into place.
Figure 3-
2
3
.
.
Pivot the upper chute upward over the lip on the lower
chute so that there is no gap between the upper  chute and
the lower chute.
Secure with the hardware just removed.  Refer to Fig. 3-3.
Chute Handle
Figure 3-1
2
.
Tighten the wing knobs to secure the  handle in place.
See Fig. 3-1.
Assembling the Discharge Chute
For shipping reasons, the snow thrower has been  packaged with
the upper chute pivoted all the way down. To pivot it upward,
proceed as follows:
1
.
Remove the wing knob, flat washer  and carriage bolt from
the lower chute. See Fig. 3-2.
Figure 3-3
6
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website