MTD 769-01283C Snow Blower Owners Manual

Replacing Auger Paddles
The snow thrower auger’s rubber paddles  are subject to wear
and should be replaced if any signs of excessive wear  are present.
CAUTON: Do NOT allow the auger’s rubber
paddles to wear to the point where portions  of the
metal auger itself can come in  contact with the
pavement. Doing so can result in serious  damage to
your snow thrower.
To change the rubber paddles,  proceed as follows:
1
.
Remove the existing rubber paddles  by unthreading the
self-tapping screws which secure  them to the auger. See
Fig. 7-3.
Figure -3
2
.
Secure the replacement rubber  paddles to the auger using
the hardware removed earlier.
Replacing Shave Plate
The shave plate is attached to the bottom  of the auger housing
and is subject to wear. It should be checked  periodically. There
are two wearing edges and the shave plate can  be reversed.
1
2
3
4
.
.
.
.
Remove the four carriage bolts and  hex lock nuts which
attach it to the snow thrower housing.
Install new shave plate, making sure the heads of  the
carriage bolts are on the inside  of the housing.
Adjust the shave plate as instructed on page  11. Refer to
Fig. 6-1.
Tighten securely once adjusted.
sectiOn 7 — service
13
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website