6
Maintaining
Your Snow
Thrower
Augers
•
The augers are secured to the spiral shaft with two
shear pins and cotter pins. If the auger should strike a
foreign object or ice jam, the snow thrower is designed
so that the pins may shear. Refer to Figure 6-9.
•
If the augers will not turn, check to see if the pins have
sheared. One set of replacement shear pins has been
provided with the snow thrower. When replacing pins,
spray an oil lubricant into shaft before inserting new
pins.
Drive Belt Replacement
To remove and replace your snow thrower’s auger belt,
proceed as follows:
1.
Remove the plastic belt cover on the front of the
engine by removing the two self-tapping screws. See
Figure 6-9.
Figure 6-9
•
Drain the gasoline from the snow thrower, or place a
piece of plastic under the gas cap.
Carefully pivot the snow thrower up and forward so
that it rests on the auger housing. See Figure 6-10.
Remove the frame cover from the underside of the
snow thrower by removing four self-tapping screws
which secure it.
NEVER replace the
auger shear pins with
standard hex pins.
Any damage to the
auger gearbox or
•
2.
other components
as a result of failing
to do so will NOT be
covered by your snow
thrower’s warranty.
3. a. Use a wrench to pivot the idler pulley toward the
right. See Figure 6-11.
b. Roll the auger belt off the engine pulley.
c. Lift the drive belt off engine pulley.
4.
•
Slip the drive belt off the pulley and between friction
wheel and friction wheel disc. See Figure 6-12.
Remove and replace belt in the reverse order.
Figure 6-10
b
c
a
Figure 6-11
Figure 6-1
16
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | MTD 769-03244, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)