MTD 769-03244 Snow Blower Owners Manual

3
Setting Up
Your Snow
Thrower
Figure 3-2
NOTE: References to
right or left side of the
snow thrower are deter-
mined from behind the
unit in the operating
position.
Figure 3-1
1.  Observe  the lower rear area of the snow thrower to
be sure both cables are aligned with roller guides.
Pull up and back on the upper handle, align the
upper handle with the lower handle. See Figure 3-1.
2.
Secure the handle by tightening the plastic wing
knob located on both the left and right sides  of the
handle. Remove and discard any rubber bands, if
present. They are for packaging purposes only. See
Figure 3-2.
NOTE: This Operator’s
Manual covers several
models, handle panels,
lights and chute cranks
are some features that
may vary by model.
3.  Position the chute assembly  over the base, seated
securely on adapter. See Figure 3-3.
4.
Close the flange keepers to secure the chute
assembly to the chute base. The flange keepers will
click into place when properly secure. See Figure
3-4.
Not all features refer-
enced in this manual
are applicable to all
Figure 3-3
NOTE: If the flange keepers will not easily  click into
place, use the palm of your hand to apply swift, firm
pressure to the back of each.
snow thrower models.
5.
Remove the flat washer and hairpin clip from the end
NOTE: Two replace-
ment auger shear pins
are included with this
manual (or stowed
of the chute directional control. See Figure 3-5.
Insert the end of the chute directional control  into
the lower bracket and secure with the flat washer
and hairpin clip just removed. If necessary, the lower
bracket can be adjusted. Refer to Chute Bracket Ad-
justment, in the Adjustment Section of this manual.
in the plastic handle
panel). Refer to Augers
in the Maintainance
Section for more
IMPORTANT: Prior to operating your snow thrower,
refer to Auger Control Test on page 11. Read and follow
all instructions carefully and perform  all adjustments
to verify your snow thrower is operating safely and
properly.
information regarding
shear pin replacement.
Figure 3-4

Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 52 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website