MTD Cub Cadet 850 SWE 1130 SWE Snow Blower Owners Manual

Unhook the idler spring from the hex bolt on the
auger housing. See Figure 14.
Back out the stop bolt until the support bracket
rests on the auger pulley.
Self-Tapping
Screw
NOTE: Loosening the six nuts that connect the frame to
the auger housing may aid in belt removal.
Lift the rear auger belt from the auger pulley, and
slip the belt between the support bracket and the
auger pulley. Repeat this step for the front auger
belt.
Replace both auger drive belts by following
instructions in reverse order.
Belt Cover
NOTE: If you placed plastic film under the gas cap, be
Figure 13
certain to remove it before operating the snow thrower.
Remove the six self-tapping screws from the frame
cover underneath the snow thrower.
Roll the front and rear auger belts off the auger
drive pulley. See Figure 14.
Drive Belt
Follow the first four steps of the instructions for
servicing the auger belts.
Pull the idler pulley up and lift the belt off the wheel
drive pulley and friction wheel disc. See Figure 14.
Back out the stop bolt until the support bracket
rests on the auger pulley. See Figure 15.
Slip the belt between the friction wheel and drive
disc. Remove and replace the belt. Reassemble
following the instructions in reverse order.
Drive
Pulley
Auger
Pulley
Drive
Belt
NOTE: The support bracket must rest on the stop bolt
Idler
Pulley
Idler
Pulley
after the new belt has been assembled.
Auger
Belts
Friction
Wheel
Drive Plate
Frame
Stop Bolt
Frame
Support Bracket
Auger Pulley
Support
Bracket
Figure 15
Replacing Friction Wheel Rubber
Rear
Auger
Belt
The rubber on the friction wheel is subject to wear and
should be checked after 25 hours of operation, and
periodically thereafter. Replace the friction wheel
rubber if any signs of wear or cracking are found.
Support
Bracket
Spring
Front
Auger Belt
Auger Housing
Drain the gasoline from the snow thrower, or place
a piece of plastic under the gas cap.
Tip the snow thrower up and forward, so that it rests
on the housing.
Idler Spring
Figure 14
13
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website