•
•
Recheck the adjustment and repeat adjustment as
necessary.
Retighten the jam nut to secure the cable when
correct adjustment is reached.
NOTE: If you are uncertain that you have reached the
correct
adjustment,
refer
to
Traction
Control
Adjustment in Adjustment Section.
SECTION3: KNOWYOURSNOWTHROWER
Traction Control /
Auger Control Lock
Shift Lever
Chute Tilt
Control
Heated Handles Switch
Headlight
Auger Drive Control
Discharge
Chute
Track Steering
Control
Electric
Starter
Button
Primer
Electric Chute
Rotation Switch
Switch
Box
Choke
Safety
Ignition Key
Recoil
Starter
Handle
Skid Shoe
Throttle
Auger
Control
Figure 7
WARNING: Read, understand, and follow
all instructions and warnings on the
machine and in this manual before
operating.
Chute Tilt Control
The distance snow is thrown can be changed by
adjusting the angle of the chute assembly. Move the
chute tilt control forward to decrease the distance,
toward the rear to increase. See Figure 7.
Traction Control / Auger Control Lock
The traction control is located on the right handle.
Squeeze the traction control to engage the wheel drive.
Release to stop. See Figure 7.
Skid Shoe
The position of the skid shoe is determined by the
condition of the ground from where snow has to be
removed. See Figure 7.
This same lever also locks the auger control so you
can turn the chute directional control without
interrupting the snow throwing process. If the auger
control is engaged along with the traction control, the
operator can release the auger control (on the left
handle) and the augers will remain engaged. Release
the traction control to stop both the augers and track
drive (auger control must also be released).
Shift Lever
The shift lever is located in the center of the handle
panel and is used to determine both ground speed and
direction of travel. It can be moved into any of eight
positions. See Figure 7.
Forward
IMPORTANT:Always release tractional control before
Your snow thrower has six forward (F) speeds. Position
number one (1) is the slowest. Position number six (6)
is the fastest.
changing speeds.
Auger Drive Control
Reverse
Your snow thrower has two reverse (R) speeds. R1 is
the slower, while R2 is the faster of the two.
The auger drive control is located on the left handle.
Squeeze the control grip to engage the augers.
Release to stop the snow throwing action. (Traction
control must also be released.) See Figure 7.
IMPORTANT: Always release tractional control before
changing speeds.
7
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 1130 SWE, Cub Cadet 850 SWE, MTD 1130 SWE, MTD 850 SWE, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)