4
Operating
Your Snow
Thrower
To Engage Drive
Auger Control Test
1.
With the engine running near top speed, move
shift lever to one of six FORWARD positions or two
REVERSE positions. Select a speed appropriate for
the snow conditions that exist.
Perform the following test before operating your snow
thrower for the first time and at the start of each winter.
Check the adjustment of the auger control as follows:
1. When the auger control is released and in the
disengaged “up” position, the cable should have very
little slack. It should NOT be tight.
2.
3.
Squeeze drive control against the right handle and
the snow thrower will move. Release it and the drive
motion will stop.
2. In a well-ventilated area, start the snow thrower
engine as instructed on the previous page. Make sure
the throttle is set in the FAST position.
To turn the unit left or right, squeeze the respective
wheel steering control. See Figure 12.
3.
While standing in the operator’s position (behind the
To Engage Augers
snow thrower), engage the auger.
1.
2.
To engage augers and start snow throwing, squeeze
the left hand auger control against the left handle.
Release to stop augers.
4. Allow the auger to remain engaged for approximately
ten (10) seconds before releasing the auger control.
Repeat this several times.
While the auger control is engaged, squeeze the drive 5. With the throttle control in the FAST (rabbit) position
control to move, release to stop. Do not shift speeds
while the drive is engaged.
and the auger control in the disengaged “up” position,
walk to the front of the machine.
6.
Confirm that the auger has completely stopped
rotating and shows NO signs of motion. If the auger
shows ANY signs of rotating, immediately return to
the operator’s position and shut off the engine. Wait
for ALL moving parts to stop before re-adjusting the
auger control.
NOTE: This same lever also locks auger control so you
can turn the chute control without interrupting the snow
throwing process.
WARNING
The muffler, engine
and surrounding areas
become hot and can cause
a burn. Do not touch.
3.
Release the auger control; the interlock mechanism
should keep the auger control engaged until the drive
control is released.
Release the drive control to stop both the augers and
the wheel drive. To stop the auger, both levers must
be released.
7.
To readjust the control cable, loosen the upper hex
nut on the auger cable bracket.
4.
8.
Position the bracket upward to provide more slack (or
downward to increase cable tension). See Figure 13.
9.
10.
Retighten the upper hex nut.
Repeat Auger Control Test to verify proper adjustment
has been achieved.
When selecting a Drive
Speed, use the slower
speeds until you are
comfortable and familiar
with the operation of the
snow thrower.
NEVER reposition the
shift lever (change speeds
or direction of travel)
without first releasing the
drive control and bringing
the snow thrower to a
complete stop. Doing so
will result in premature
wear to the snow
thrower’s drive system.
Figure 13
11
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet WE 26, MTD Snow Blower Manual, MTD WE 26 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)