8
Trouble-
shooting
Problem
Engine fails to start 1. Choke not in ON position.
Cause
Remedy
1. Move choke to ON position.
2. Connect wire to spark plug.
3. Fill tank with clean, fresh gasoline.
2.
3.
4.
Spark plug wire disconnected.
Fuel tank empty or stale fuel.
Engine not primed.
4. Prime engine as instructed in
“Operating Your Snow Thrower”.
5.
6.
7.
Faulty spark plug.
5. Clean, adjust gap, or replace.
6. Clean fuel line.
Blocked fuel line.
Safety key not in ignition on engine.
7. Insert key fully into the switch.
Engine runs erratic
Engine overheats
1
. Unit running on CHOKE.
1. Move choke lever to OFF position.
2. Cleanfresh gasoline.fuel line; fill tank with clean,
2
. Blocked fuel line or stale fuel.
3
. Water or dirt in fuel system.
. Carburetor out of adjustment.
3. Drain fuel tank. Refill with fresh fuel.
4. Contact Cub Cadet Service Dealer.
This section
addresses minor
service issues.
4
1. Carburetor not adjusted properly.
1. Contact Cub Cadet Service Dealer.
For further details,
contact your nearest
Cub Cadet service
dealer or call
Excessive
1. Loose parts or damaged auger.
1. Stop engine immediately and discon-
nect spark plug wire. Tighten all bolts
and nuts. If vibration continues, have
unit serviced by a Cub Cadet Service
Dealer.
Vibration
1-877-282-8684.
Loss of power
1. Connect and tighten spark plug wire.
1.
Spark plug wire loose.
2
. Gas cap vent hole plugged.
2. BeRemovecertainiceventandholesnowis fromclear.gas cap.
3
. Exhaust port plugged.
3. Contact Cub Cadet Service Dealer.
to propelUnit failsitself
1. Drivement.control cable in need of adjust-
1.
Adjust drive control cable. Refer to
“Making Adjustments”.
2
. Drive belt loose or damaged.
2. Replace drive belt.
to dischargeUnit failssnow
1. Chute assembly clogged.
1. Stop engine immediately and discon-
nect spark plug wire. Clean chute
assembly and inside of auger housing
with clean-out tool or a stick.
2
3
. Foreign object lodged in auger.
2. Stop engine immediately and discon-
nect spark plug wire. Remove object
from auger with clean-out tool or a
stick.
. Amuegnet.r control cable in need of adjust-
3. Refer to “Auger Control Test” in
Operation section.
4. Auger belt loose or damaged.
. Shear pin(s) sheared.
4. Refer to Maintenance section.
5. Replace with new shear pin(s).
5
19
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet WE 26, MTD Snow Blower Manual, MTD WE 26 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)