SECTION8: SERVICE
WARNING: Disconnect the spark plug wire
and ground against the engine before
performing any repairs or maintenance.
•
Unhook the idler spring from the hex bolt on the
auger housing. See Figure 18.
Friction Wheel
Engine
Refer to the separate engine manual packed with your
unit for all engine related maintenance procedures.
Belt Removal And Replacement
Frame
WARNING: Disconnect the spark plug
wire from the spark plug and ground.
Support
Bracket
Auger Belt
Auger Belts
•
Remove the plastic belt cover by removing the two
self-tapping screws. See Figure 16.
Idler
Spring
Support
Bracket
Auger Spring
Auger
Pulley
Belt
Cover
Housing
Figure 18
•
Back out the stop bolt until the support bracket
rests on the upper auger pulley. See Figure 19.
Friction
Wheel Disc
Friction Wheel
Drive Belt
Self-Tapping Screws
Figure 16
•
•
Drain the gasoline from the snow thrower.
Support Bracket
Tip the snow thrower forward so that it rests on its
auger housing and remove six self-tapping screws
from the frame cover underneath the snow thrower.
Roll the belt off the engine pulley. See Figure 17.
Stop
Bolt
•
Drive
Belt
Auger Pulley
Auger Pulleys
Engine
Pulley
Figure 19
Auger
Belt
NOTE: Loosening the six nuts that connect the frame to
the auger housing may aid in belt removal.
•
Lift the rear auger belt from the auger pulley, and
slip belt between the support bracket and the auger
pulley. See Figure 18. Repeat this step for the front
auger belt.
Engine
Pulley
Idler
Pulley
Idler
Pulley
•
Replace both auger drive belts by following
instructions in reverse order.
Figure 17
13
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | MTD E663G, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)