MTD E663G Snow Blower Owners Manual

Electric Start: Do NOT prime engine. Push starter
button on top of the engine to crank the engine.
When engine starts, release starter button.
Recoil Start: Grasp starter handle (see Figure 7)
and pull rope out slowly, until it pulls slightly harder.
Let rope rewind slowly. Pull starter handle rapidly.
Do not allow handle to snap back. Allow it to rewind
slowly while keeping a firm hold on the starter
handle.
Squeeze the traction control against the right
handle and the snow thrower will move. Release it
and the drive motion will stop.
IMPORTANT: NEVER move shift lever without first
releasing the traction control. Doing so will cause
premature wear to drive system’s friction wheel rubber.
To Engage Augers
To engage the augers and start the snow throwing
action, squeeze the auger control against the left
handle.
As engine warms up and begins to operate evenly,
rotate choke knob slowly to OFF position. If engine
falters, return to FULL choke, then slowly move to
OFF position.
To disengage power to the augers, release both the
auger control and the traction control, if engaged,
To Stop Engine
NOTE: The  auger control  can also  be locked so  you
can
turn
the
chute
directional
control
without
Run engine for a few minutes before stopping to
help dry off any moisture on the engine.
To help prevent possible freeze-up of starter,
proceed as follows:
interrupting   the  snow   throwing   process.  Refer   to
Traction Control/ Auger Control Lock in Section 4 of this
manual.
Electric Starter: Connect power cord to switch box
on engine, then to 120 volt AC receptacle. With the
engine running, push starter button and spin the
starter for several seconds. The unusual sound
made by spinning the starter will not harm engine
or starter. Disconnect the power cord from recepta-
cle first, and then from switch box.
Tire Chains (Optional Equipment)
Tire chains should be used whenever extra traction is
needed. Call our Customer Support Department as
instructed on Page 2 of this manual for information
regarding availability of tire chains and other optional
accessories for your snow thrower.
Recoil Starter (Optional Instructions): With
engine running, pull starter rope with a rapid, con-
tinuous full arm stroke three or four times. Pulling
the starter rope will produce a loud clattering
sound, which is not harmful to the engine or
starter.
Operating Tips
NOTE: Allow the engine to warm  up for a few minutes
as the engine will not develop full power until it reaches
operating temperature.
To stop engine, remove the ignition key. Do not turn
key. Disconnect the spark plug wire from the spark
plug to prevent accidental starting while equipment
is unattended.
WARNING:  Temperature  of  muffler and
surrounding  areas  may   exceed  150oF.
Avoid these areas.
Set the skid shoes 1/4" below the shave plate for
normal usage. The skid shoes may be adjusted
upward (to lower the shave plate) for hard-packed
snow. Adjust downward (to raise the shave plate)
when using on gravel or crushed rock.
NOTE: Do not lose ignition key. Keep it in a safe place.
Engine will not start without the ignition key.
Wipe all snow and moisture from the carburetor
cover in the area of the control levers. Also, move
control levers back and forth several times. Leave
throttle control lever in the STOP or OFF position.
Leave choke control in the FULL choke position.
Remove snow immediately after it falls.
Discharge snow downwind whenever possible.
Slightly overlap each previous cleared path.
Follow the precautions found under the heading To
Stop Engine to prevent possible freeze-up.
Clean the snow thrower thoroughly after each use.
To Engage Drive
With the engine running near top speed, move shift
lever into one of the six FORWARD positions or two
REVERSE positions. Select a speed appropriate
for the snow conditions that exist.
NOTE:  Use the  slower speeds  until  you are  familiar
with the operation of the snow thrower.
9
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website