NOTE: If the connector is not properly assembled, the
shift rod will pivot and you will not be able to change
speeds or change directions.
Use middle or high position when area to be cleared is
uneven. See Figure 5.
•
Unwrap the headlight wire which is attached to the
headlight, beneath the handle panel. Wind the
headlight wire around the right handle until excess
slack is removed.
•
Plug the wire from the headlight into the wire lead
coming from the right side of the engine, beneath
the fuel tank.
Final Adjustments
Auger Control Adjustment
Check the adjustment of the auger control as follows:
Skid
Shoes
•
•
Push forward on the auger control (Refer to Figure
until the small rubber bumper contacts the upper
handle. There should be slack in the cable.
Hex Nuts
6)
Figure 5
Release the auger control. The cable should be
straight. Make certain you can depress the auger
control against the left handle completely.
IMPORTANT: It is NOT recommended that this snow
thrower be operated on a gravel surface, as loose
stones can be easily picked up and thrown by the
machine. If you must operate on a gravel surface,
ALWAYS adjust the skid shoes into the HIGH position
to allow the shave plate maximum clearance.
If adjustment is necessary, proceed as follows:
•
Loosen the jam nut and thread the cable in (for less
slack) or out (for more slack) as necessary. See
Figure 4.
Adjust skid shoes as follows:
•
Loosen, but do NOT remove, the two hex nuts
which fasten the skid shoe to the auger housing.
Raise or lower the skid shoe to desired position.
•
NOTE: Make certain the entire base of both skid shoes
are against the ground to avoid uneven wear on the
skid shoes.
“
Z” End
•
•
Retighten the hex nuts loosened earlier.
Repeat this adjustment on the skid shoe found on
the opposite side of the snow thrower.
Jam Nut
Tire Pressure Adjustment
The tires are over-inflated for shipping purposes.
Adjust the tire pressure to between 15 psi and 20 psi.
Auger Control Cable
NOTE: If the tire pressure is not equal in both tires, the
unit may pull to one side or the other.
Figure 4
Traction Control and Shift Lever Adjustment
•
Recheck the adjustment before retightening the
jam nut against the cable.
To check the adjustment of the traction control and shift
lever, proceed as follows:
•
Move the shift lever into sixth (6) position.
a. With the traction control (refer to Figure 6 in
Section 4 of this manual) released, gently
push the snow thrower forward, then pull it
back. Disregarding the overall weight of the
snow thrower, the machine should otherwise
move freely.
Skid Shoe Adjustment
The space between the shave plate and the ground can
be adjusted by repositioning the skid shoes found on
either side of the snow thrower’s auger housing. For
close snow removal, place skid shoes in the low
position.
6
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | MTD E663G, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)