MTD OEM 190-627 Snow Blower Owners Manual

Adjust skid shoes as follows:
1.
Loosen, but do NOT remove, the three hex nuts
which fasten the skid shoe to the auger housing.
Raise or lower the skid shoe to desired position.
2.
NOTE: Make certain the entire base of both skid shoes
are  against the  ground to avoid  uneven wear on the
skid  shoes.  When  one  side  does  wear  out,  the  skid
shoes are reversible.
3.
4.
Retighten the hex nuts loosened earlier.
Repeat this adjustment on the skid shoe found on
the opposite side of the snow thrower.
Engagement/Disengagement Adjustment
If the snow throwers auger and impeller:
a.   Fail to engage when lowering the tractors lift
lever and placing it into the lowest notch
possible, or
Skid Shoe
Hex Nuts
Figure 19
b.   Fail to disengage when raising the tractors
lift lever and placing it into the Blades Stop
notch, perform the following adjustment.
Engagement Plate
1.
2.
Place the tractors lift lever in the second
engagement notch (third notch down).
Locate the control rod found to the inside of the
engagement plate on the undercarriage assembly.
See Figure 20 .
3.
4.
Remove the hairpin clip and flat washer from the
ferrule found at the rear of the control rod. See
Figure 20 .
Remove the ferrule from the hole in the
engagement plate and slide the control rod as far
forward as it will go in the slot in the idler bracket.
See Figure 21 .
Idler Bracket
IMPORTANT: Do not attempt to force the control rod
beyond the end of the slot in the idler bracket. The idler
bracket is under tension from the spring which secures
it to the tractors frame rail.
Ferrule
Control Rod
Figure 20
Engagement Plate
5.
While holding the control rod forwardmost end of
the slot, thread the ferrule inward or outward
(whichever is applicable) until it is realigned with
the hole.
6.
Reinsert the ferrule into the hole and secure it to the
engagement plate by fastening with the flat washer
and hairpin clip removed in Step 3.
Slot
Control Rod
Ferrule
Figure 21
13
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 20 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website