RH Transmission
Bypass Rod
1. Change the engine oil and filter following the
instructions provided in the engine manual packed
with this manual.
WARNING!: Never store the tractor with fuel
in the tank indoors or in poorly ventilated
enclosures, where fuel fumes may reach an
open flame, spark or pilot light as on a furnace,
water heater, clothes dryer, etc.
Pull out
Bypass Rod
Then Lower
in Slot
2
. If storing the tractor for 30 days or more:
To prevent gum deposits from forming inside the
engine’s carburetor and causing possible malfunction
of the engine, the fuel system must be either
completely emptied, or the gasoline must be treated
with a stabilizer to prevent deterioration.
Keystone
Slot
WARNING!: Fuel left in the fuel tank
deteriorates and will cause serious starting
problems.
Figure 6-3
•
•
Repeat the above procedure to engage the other
bypass rod on the other side of the tractor.
Using a fuel stabilizer:
Read the product manufacturer’s instructions and
recommendations.
After moving the tractor, disengage both bypass rods.
Lift the rod and guide the flange of the rod back
through the larger circular opening of the keyhole,
then release the rod.
•
•
Add to clean, fresh gasoline the correct amount of
stabilizer for the capacity (approximately 3 gallons) of
the fuel system.
IMPORTANT: The tractor will not drive with the bypass rods
•
Fill the fuel tank with treated fuel and run the
engine for 2-3 minutes to get stabilized fuel into the
carburetor.
in the engage position.
Battery Storage
Emptying the fuel system:
•
•
•
When storing the tractor for extended periods,
disconnect the negative battery cable. It is not
necessary to remove the battery.
•
•
•
Prior to putting the tractor in storage, monitor fuel
consumption with the goal of running the fuel tank
empty.
All batteries discharge during storage. Keep the
exterior of the battery clean, especially the top. A dirty
battery will discharge more rapidly.
Run the engine until it begins to stall. Use the choke to
keep the engine running until all fuel in the carburetor
has been exhausted.
The battery must be stored with a full charge. A
discharged battery can freeze sooner than a charged
battery. A fully charged battery will store longer in cold
temperatures than hot.
Referring to the engine manual, drain the fuel from the
carburetor bowl.
3. Clean the engine and the entire tractor thoroughly.
•
Recharge the battery before returning to service.
Although the tractor may start, the engine charging
system may not fully recharge the battery.
4
. Fully charge the battery, then disconnect the negative
cable at the battery to prevent possible discharge.
Recharge the battery periodically when in storage.
NOTE: Remove the battery if exposed to prolonged
periods of sub-freezing temperatures. Store in a cool, dry
location where temperatures are above freezing.
Tractor Storage
If your tractor is not going to be operated for an extended
period of time (thirty days to approximately six months),
the tractor should be prepared for storage. Store the
tractor in a dry and protected location. If stored outside,
cover the tractor (including the tires) to protect it from
the elements. The procedures outlined below should be
performed whenever the tractor is placed in storage.
5
. Lubricate all lubrication points.
NOTE: We do not recommend the use of a pressure washer or
garden hose to clean your tractor. They may cause damage
to electrical components; spindles; pulleys; bearings; or the
engine. The use of water will result in shortened life and
reduce serviceability.
22
sectiOn 6— Maintenance & adjustMents
Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
---|---|
Tags | MTD RZT, Troy-Bilt RZT |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | MTD, Lawn Mower |
Document File Type | |
Publisher | mtdproducts.com |
Wikipedia's Page | MTD Products |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)