5
Maintaining
Your Lawn
Mower
Lubrication
•
Lubricate pivot points on the blade control at least
once a season with light oil. The blade control must
operate freely in both directions. See Figure 5-1.
•
Lubricate the wheels at least once a season with
light oil (or motor oil). If wheels are removed for any
reason, lubricate surface of the pivot arm and inner
surface of the wheel with light oil. See Figure 5-1.
•
Lubricate the torsion spring and pivot point on the rear
discharge door and side discharge chute periodically
with light oil to prevent rust. See Figure 5-1.
•
•
The transmission is pre-lubricated and sealed at the
factory and does not require lubrication.
Follow the accompanying engine manual for engine
lubrication instructions.
Deck Care
The underside of the mower deck should be cleaned
after each use to prevent any build-up of grass clippings,
leaves, dirt, or other debris. If this debris is allowed to
accumulate, it will result in rust and corrosion.
Figure 5-1
1.
2.
Disconnect spark plug wire. Drain gasoline from lawn
mower, or place a piece of plastic under the gas cap.
WARNING
Tip mower so that it rests on the housing. Keep the
side with the air cleaner facing up. Hold mower firmly.
Always stop engine,
disconnect spark
plug, and ground
against engine before
cleaning, lubricating
or doing any kind of
maintenance on your
machine.
WARNING: Never tip the mower more than
90º
in any direction and do not leave the
mower tipped for any length of time. Oil can
drain into the upper part of the engine causing a
starting problem.
3.
Scrapesuitableandtool.cleanDo notthesprayundersidewith water.of the deck with a
4.
Put the mower back on its wheels on the ground. If
you had put plastic under the gas cap earlier, make
sure to remove it now.
Figure 5-2
Engine Care
A list of key maintenance jobs required for good
performance by the mower is given below. Follow the
accompanying engine manual for detailed list and
instructions.
General Recommendations
•
Always observe safety rules when performing
any type of maintenance.
•
•
Maintain oil level as instructed in engine manual.
•
The warranty on this lawn mower does not cover
items that have been subjected to operator abuse
or negligence. To receive full value from warranty,
operator must maintain the lawn mower as
instructed here.
Service air cleaner every 25 hours under normal
conditions. Clean every few hours under extremely
dusty conditions. Refer to engine manual.
We do not recommend
the use of pressure
washers or garden
hose to clean your
unit. These may cause
damage to electric
components, spindles,
pulleys, bearings, or
the engine. The use
of water will result in
shortened life and
•
•
Clean spark plug and reset the gap once a season.
Check engine manual for correct plug type and gap
specifications.
•
•
•
Changing of engine-governed speed will void
engine warranty.
Clean engine regularly with a cloth or brush. Keep the
cooling system (blower housing area) clean to permit
proper air circulation. Remove all grass, dirt and
combustible debris from muffler area.
All adjustments should be checked at least once
each season.
Periodically check all fasteners and make sure these
are tight.
WARNING: Always stop engine,
disconnect spark plug, and ground
against engine before performing any
Replacing Rear Flap
1.
Toeitherremoveside torearremoveflap, liftfromrearhole.door,SeeandFigurepress5-2.flap in on
reduce serviceability.
type of maintenance on your machine. 2. flapRemovein theflapoppositefrom oppositeorder andholemannerand replaceof removal.with new
10
Categories | Blower Vacuum and Sweeper Manuals, Lawn Mower Manual, MTD Blower and Vacuum Manuals, MTD Lawn Mower Manuals, Troy-Bilt Blower and Vacuum Manuals, Troy-Bilt Lawn Mower Manuals |
---|---|
Tags | MTD V560, Troy-Bilt V560 |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | MTD, Lawn Mower |
Document File Type | |
Publisher | mtdproducts.com |
Wikipedia's Page | MTD Products |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)