1.
Refer to the separate engine manual, packed with
your unit, for carburetor adjustment information
Replacing Belt
WARNING: Beforeservicing, repairing,
or inspecting, disengage the control
bail andstopengine. Wait until all
moving parts have come to a complete
stop. Disconnect sparkplugwireand
ground it against the engine to prevent
unintendedstarting.
6
Idler Pulley
Adjustments
&
Maintenance
Remove the belt cover by removing five hex screws. See
Figure 9. Then simply pull the belt off by grasping it from the
bottom of the auger pulley and pulling off. Once you remove
the belt from the pulleys, you can push down on the idler
pulley to release the belt from under the belt keeper.
Belt Keeper
To replace the belt follow these instructions and refer to
Figure 10:
To remove, pull belt off here
Figure 9
1
. PushdownontheIdler pulley.
WARNING
2.
Put belt on top of the auger pulley, under belt keeper.
1
3
. Threadbelt aroundenginepulley.
Beforeservicing,
repairing,orinspecting,
disengagethecontrol
bailandstopengine.
Waituntilallmoving
partshavecome
toacompletestop.
Disconnectsparkplug
wireandgroundit
againsttheengineto
preventunintended
starting.
3
4. Push belt over bottom of auger pulley.
Reinstall the belt cover removed earlier.
Engine
Refer to the separate engine manual for all engine
maintenance procedures.
1.
2.
2
Check engine and snow thrower frequently for loose
hardware, and tighten as needed.
Lubrication
Lubricatepivot pointsonthecontrol handleandthe
extension spring at the end of the control cable with a
light oil once every season and before storage of the
snow thrower at the end of the season.
4
Figure 10
Replacing Auger Paddles
The snow thrower auger’s rubber paddles are subject to
wear and should be replaced if any signs of excessive
wear is present.
IMPORTANT:
Do NOT allow the
auger’s rubber paddles
to wear to the point
where portions of the
metal auger itself can
come in contact with
the pavement. Doing
so can result in serious
damage to your snow
thrower.
IMPORTANT: Do NOT allow the auger’s rubber paddles
to wear to the point where portions of the metal auger
itself cancomeincontact withthepavement. Doingso
canresult inseriousdamagetoyour snowthrower.
NOTE: Call 1-800-800-7310for informationregardingthe
priceandavailabilityof Auger Kit 753-04472or contact
an authorized MTD Service Dealer in your area.
Tochangetherubber paddles, proceedasfollows:
1.
Remove the existing rubber paddles by unscrewing the
self-tapping screws which secure them to the auger.
See Figure 11.
2.
Secure the replacement rubber paddles to the auger
using the hardware removed earlier.
Figure 11
11
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, White Outdoor Snow Blower Manuals |
|---|---|
| Tags | MTD 235, MTD S235, MTD Snow Blower Manual, White Outdoor 235, White Outdoor S235 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)