5
5.
If youhaveagroundedthree-prongreceptacle,
proceedasfollows.
Disconnect the power cord from receptacle first, and
then from switch box.
6.
7.
MoveChokeControl tothe“Full” position.
3. Recoil Starter: With engine running, pull starter rope
with a rapid, continuous full arm stroke three or four
times. Pulling the starter rope will produce a loud
clattering sound, which is not harmful to the engine
or starter.
PushPrimer three(3) times, makingsuretocover
vent holewhenpushing.
8.
Connect power cordtoswitchboxondashpanel.
Plugtheother endof power cordintoathree-prong
Operation
4.
Wipe all snow and moisture from the carburetor
cover in the area of the control levers. Also, move
control levers back and forth several times. Leave
choke control in the FULL choke position.
120-volt,
grounded, ACreceptacle.
Pushstarter buttontocrankengine.
enginestarts, releasestarter button, andmove
9.
10.When
chokegraduallyto1/2Chokeuntil theengineruns
smoothly. Next moveChoketoOFF. If enginefalters,
movechokeimmediatelytoFULLandthengradually
to1/2thentoOFF.
5.
Remove ignition key and disconnect spark plug wire
to prevent accidental starting.
Operating the Snow Thrower
11.
Disconnect thepower cord. Alwaysunplugfromthe
outlet first, andthenfromthesnowthrower.
The pitch of the chute assembly controls the angle at
which the snow is thrown.
WARNING
1.
Loosen the wing knob found on the left side of the
chute assembly and pivot the upper chute upward or
downward to the desired pitch. Retighten the wing
knob before operating the snow thrower.
Recoil Starter
Movechokelever toFULLchokeposition(coldengine
start).
Muffler, engine and
surrounding areas
become hot and
can cause a burn.
Do not touch.
1.
2.
3.
4.
If engineiswarm, placechokeinOFFpositioninstead 2. Position the chute assembly opening by using the
of FULL.
Chute Handle to throw the snow in the desired
direction. See inset Figure 5A on page 8.
PushPrimer three(3) times, makingsuretocover
vent holewhenpushing.
Never operate the
snow thrower with
bystanders in front of
or near the discharge
chute opening.
Clearing Snow
WARNING: Never operate the snow
thrower with bystanders in front of or
near the discharge chute opening.
If engineiswarm, pushprimer buttononlyonce.
NOTE: Alwayscover vent holeinprimer buttonwhen
pushing. Additional primingmaybenecessaryfor first
start if temperatureisbelow15degreesFahrenheit.
1.
Engage the auger
by squeezing the
auger control handle
against the upper
handle. See Figure 6.
5.
Graspstarter handleandpull ropeout slowly, until it
pullsslightlyharder. Let roperewindslowly.
6.
Pull starter handlerapidly. Donot allowhandletosnap
back. Allowit torewindslowlywhilekeepingafirm
holdonthestarter handle.
2. Lift up slightly on the
handle to allow the
rubber paddles on
7.
1.
Asenginewarmsupandbeginstooperateevenly,
rotatechokelever slowlytothe1/2Chokeposition.
Whentheenginebeginstorunsmoothly, movethe
choketotheOFFposition. If enginefalters, return
toFULLchoke, thenslowlymoveto1/2thenOFF
position.
Figure 6
the auger to contact
NOTE:
the pavement and propel the snow thrower forward.
Pushing downward on the handle will raise the
augers off the ground and stop forward motion.
Excessive upward
pressure on the
handle will result in
premature wear
on the rubber
auger blades which
would not be covered
by warranty.
3.
Discharge snow downwind whenever possible.
Slightly overlap each previously cleared path.
To Stop Engine
Tostopengine, turnignitionkeycounter-clockwise.
Disconnect thesparkplugwirefromthesparkplug
toprevent accidental startingwhileequipment is
unattended.
NOTE: Excessive upward pressure on the handle will
result in premature wear on the rubber auger blades
whichwouldnot becoveredbywarranty.
Operating Tips
Run the engine for a few minutes before stopping to
helpdryanymoistureontheengine.
Tohelpprevent possiblefreeze-upof starter,
proceedasfollows:
Runenginefor afewminutesbeforestoppingtohelp
dryoff anymoistureontheengine.
1.
2.
Excessive upward
pressure on the handle
will result in premature
wear on the rubber auger
blades which would not
be covered by warranty.
1.
Clean the snow thrower thoroughly after each use.
2.
ElectricStarter: Connect power cordtoswitchbox
onengine, thento120volt ACreceptacle. Withthe
enginerunning, pushstarter buttonandspinthe
starter for several seconds. Theunusual soundmade
byspinningthestarter will not harmengineor starter.
WARNING: Muffler, engine and
surroundingareasbecomehot and
can cause a burn. Be careful and do
not touch when hot.
9
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, White Outdoor Snow Blower Manuals |
|---|---|
| Tags | MTD 235, MTD S235, MTD Snow Blower Manual, White Outdoor 235, White Outdoor S235 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)