MTD Yard Machines E762F Snow Blower Owners Manual

AUGER CLUTCH ADJUSTMENT
To   adjust   the  auger   clutch,   refer   to   the   Final
Adjustments section page 10.
Drive Shaft
SHIFT ROD ADJUSTMENT
Drive
Cable
To adjust the shift rod, remove the hairpin clip and
flat washer which secure the ferrule to the shift lever,
beneath the handle panel. Refer to Figure 15. Refer
to the Final Adjustments section.
Sprocket
Shaft
CARBURETOR ADJUSTMENT
Pivot
Rod
Friction
Wheel
WARNING: If   any   adjustments   are
made to the engine while the engine is
running (e.g. carburetor), keep clear of
all  moving  parts.  Be  careful  of  heated
surfaces and muffler.
Friction
Plate
Minor  carburetor   adjustment  may  be   required  to
compensate  for   differences   in  fuel,   temperature,
altitude and load.
Figure 20  
Refer  to  the  separate  engine  manual  packed  with
your unit for carburetor adjustment information.
SECTION 9:  LUBRICATION
WARNING: Disconnect
the
spark
ENGINE
plug   wire    and   ground    against   the
Refer  to  engine  manual  for   all  engine  lubrication
instructions.
engine
before
performing
any
lubrication or maintenance.
AXLE BEARINGS
AUGER SHAFT
Oil  or   spray  lubricant   into  axle   bearings  at   the
housing at least once a season.
At least once a season, remove shear bolts on auger
shaft. Oil or spray lubricant inside shaft. See Figure
21. Also lubricate the plastic bearings at least once a
season.
SPROCKET SHAFT
Lubricate  the  sprocket  shaft  with  good  all-weather
multi-purpose light grease at least once a season or
after every 25 hours of operation.
IMPORTANT:  Keep  all  grease  and  oil  off  of  the
rubber friction wheel and aluminum drive plate.
Shear Bolts
DRIVE AND SHIFTING MECHANISM
At  least  once  a  season  or  after  every  25  hours  of
operation, remove rear cover. Lubricate any chains,
sprockets,   gears,   bearings,   shafts,   and   shifting
mechanism at least once a season. Use engine oil
or  a  spray  lubricant.  Avoid  getting  oil  on  rubber
friction wheel and aluminum drive plate.  Refer to
Figure 20.
Plastic Bearings
Figure 21  
14
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 30 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower, Yard Machines, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website