Murray 612100x30NA 12-Inch Electric Snow Shovel Owners Manual

ASSEMBLY
Your snow shovel was completely assembled at the  factory,
except for the upper handle assembly.
Screws
Shipping Carton
Carefully remove complete unit from carton. Make sure parts  bag
and all components have been removed before  discarding
carton.
The shipping carton contains the following items:
S
S
Snow shovel housing, with lower handles attached.
Center Grip
Plastic Probe
Upper handle loosely attached to lower handle by the  wire
harness.
Strain Relief
Figure 1
S
Plastic bag, containing the following parts (Figure  1):
S   Owner’s Manual
S
Plastic
probe
S   Set center grip (left & right pieces)
S   Strain Relief
S
(4)
#8
X
3/4
screws
Upper Handle
Tube
Assembly
1.
Remove and discard wire protector from lower handle tube.
Figure 2.
Lower Handle
Tube
NOTE: Care should be given as not to damage wire harness
while assembling snow shovel.
Figure 2
2.
Slide the upper handle assembly into the lower  handle.
NOTE: You may find it difficult to slide the upper handle
assembly into the lower handle during initial assembly.  This
is due to the close tolerance fit between the upper and lower
tubes, required to ensure a rigid assembly.  If this problem
arises proceed as follows:
Center Grip
S
S
S
Place a small amount of grease or oil on the inside of  lower
tubes. This will ensure a smooth and even fit  when sliding
upper tubes into lower tubes.
*
Arrow Down
Fold wire harness, and insert excess wire into lower  right
handle tube. Put as much of the wire harness as  possible into
lower tube.
Handle Tube
While holding lower grip firmly, carefully slide the  right and left
upper handle tubes into lower handle tubes until two  holes are
aligned evenly on both sides. DO NOT DAMAGE WIRE
HARNESS. Figure 2.
Figure 3
S
Wipe off any excess grease or oil.
3.
Position left center grip, point arrow (found inside of  grip)
down, towards the shovel housing, onto handle so  that the
tabs in the grip align with the holes on handle  tubes. Figure 3.
4.  Press left grip firmly against handle tubes, it will snap into
position. Figure 3.
4
F-041018C
Product Specification
CategoriesMurray Snow Blower Manuals, Snow Blower Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website