ASSEMBLY
You may find it necessary to use the plastic probe furnished to
ensure power cord will not be pinched or damaged when
attaching the center grips.
5.
Insert plastic probe into holes in handle. Maneuver probe to
ensure the wire harness will not be pinched when installing
center grips.
CAUTION: Do not pinch or damage wire harness while
installing center grip.
6.
Place right center grip, point arrow (found inside of grip) down
towards the shovel housing, onto handle tube aligning holes.
Press firmly in place. Figure 4
Center Grip
7.
Secure center grips to handle using four #8 X 3/4 poly screws
provided. Figure 5
Figure 4
NOTE: Thoroughly inspect the entire snow shovel for any
loose and/or damage parts prior to using this unit.
Securing the Extension Cord
S
Use only approved outdoor extension cords of adequate
gauge (16 gauge recommended) which accept the appliance’s
plug. Replace or repair damaged cord. Extension cords are
available at your dealer.
S
S
If extension cord is damaged in any manner while plugged in,
pull extension cord from wall receptacle.
The use of any extension cord will cause some loss of power.
To keep this to a minimum and to prevent overheating and
motor burn–out,, use the table below to determine the
minimum wire size (A.W.G.) extension cord.
Poly Screws
Extension Cord Length
Wire Size A.W.G.
25–100
Feet
Feet
16
14
Figure 5
100–150
Do not exceed 150 feet in extension cord length. Attach strain
relief to trigger stock as follows:
Trigger Lock
Trigger
Looped Strain Relief
Figure 6
F-041018C
5
Categories | Murray Snow Blower Manuals, Snow Blower Manuals |
---|---|
Tags | Murray 612100x30NA |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)