OPERATION
TRACTION LOCK PINS
The right traction wheel can be completely released using the locking pin
(A, Figure 6). This allows the unit to be easily moved with the engine off.
A
Traction Lock Pins
Figure 6
CHECK THE OIL (BEFORE STARTING ENGINE)
TEMPERATURE
TYPE OF OIL
S.A.E. 5W30
Synthetic 5W30
0°F
0°F
(-18°C) and above
(-18°C) and below
NOTE: The engine was shipped from the factory filled with oil.
Check the level of the oil. Add oil as needed.
1.
Make sure the unit is level. Use a high quality detergent oil classified
“For Service SG, SH, SJ, SL, or higher”.
SAE VISCOSITY GRADES
2.
3.
4.
Remove the oil fill cap/dipstick (A, Figure 7) and wipe with a clean cloth.
Insert the oil fill cap/dipstick and turn clockwise to tighten.
Remove the oil fill cap/dipstick and check the oil.
5W30
NOTE: Do not check the level of the oil while the engine runs.
Synthetic 5W30
5.
If necessary, add oil until the oil reaches the FULL mark on the oil fill
cap/dipstick. Do not add too much oil.
F
−20 0 20 32 40
6.
Tighten the oil fill cap/dipstick securely each time you check the oil
level.
C
−30
−20
−10 0 10
NOTE: For extreme cold operating conditions of 0°F (-18°C) and
below, use a synthetic 5W30 motor oil for easier starting.
NOTE: S.A.E. 5W30 motor oil may be used to make starting
easier in areas where the temperature is 20°F (-7°C) to 0°F
FULL
(-18°C).
Synthetic 5W30 is acceptable for all temperatures.
A
DO NOT mix oil with gasoline. See Chart for oil
recommendations.
Checking the Oil
Figure 7
14
| Categories | Murray Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Murray 1695722 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)