Operation
GROUND SPEED SELECTOR
Use the speed selector (A, Figure 2) to control the drive
speed of the snowthrower. There are five forward speeds
and two reverse speeds.
Use the lower speeds to blow deep or wet snow. Use the
higher speeds to blow light snow or to drive the snow-
thrower without blowing snow.
A
B
To change speeds, release the auger control lever (B,
Figure 2), then move the speed selector to the desired
setting. Fully depress the control levers to resume.
ENGINE SPEED
Always run the snowthrower at full throttle.
DEFLECTOR
The distance of the discharged snow is mainly controlled
by the position of the deflector. (Engine speed also
affects distance of discharge.) The more the deflector is
tilted UP, the farther snow will be thrown.
Figure 3. Remote Deflector Control
A. Maximum Throwing Position
B. Spring
1.
Push the remote deflector control (C) to the left to
UNLOCK the control. Sliding the contort forward(B)
will put the deflector to the maximum throwing posi-
tion (A). Sliding the control backwards to decrease
the throwing distance.
2.
Release the control to LOCK in place when the
desired angle has been chosen.
SCRAPER BAR & SKID SHOES
On smooth surfaces such as concrete or asphalt, the
scraper bar (A, Figure 4) should scrape the surface. On
surfaces such as gravel, the scraper bar should be high
enough so that it will not pick up gravel or debris.
A
C
B
The height of the scraper bar (A) is controlled by raising
or lowering the skid shoes (B).
1.
To raise the scraper bar height, rest the scraper bar
(A) on a strip of wood equal in thickness to the desired
height.
Figure 4. Skid Shoe Adjustment
A. Scraper Bar
B. Skid Shoe
2.
3.
4.
5.
6.
Make sure the scraper bar is parallel to the ground
surface.
Loosen the skid shoe nuts (C) and let the skid shoes
(B) drop to the surface.
Tighten the nuts (C), making sure the skid shoes are
adjusted equally and are parallel to the surface.
To lower the height of the scraper bar, raise the skid
shoes.
If the scraper bar becomes worn, it can be replaced
by removing the hardware attaching it to the
snowthrower.
C. Nuts
15
| Categories | Simplicity Snow Blower Manuals, Snapper Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Simplicity 1695302, Simplicity 1695311, Simplicity 1695313, Simplicity 1695314, Simplicity 1695410, Simplicity 1695411, Snapper 1695302, Snapper 1695311, Snapper 1695313, Snapper 1695314, Snapper 1695410, Snapper 1695411 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Simplicity, Snow Blower |
| Document File Type | |
| Publisher | simplicitymfg.com |
| Wikipedia's Page | Simplicity Outdoor |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)