Simplicity Snapper 8526 9528 10530 11532 1694984 82 93 85 83 94 86 9596 Large Frame Snow Blower Owners Manual

Service
Traction Drive Belt
If the snow thrower will not move forward, check the trac-
tion drive belt for wear or damage. If the traction drive
belt is worn or damaged, replace the belt as follows.
1.
2.
Disconnect the spark plug wire.
Remove the auger drive belt. See “How To Remove
The Auger Drive Belt” in the Service section.
3.
4.
Remove the e-ring (J, Figure 26) from one end of the
swing plate axle rod (I).
Remove the swing plate axle rod (I) to allow the
swing plate (A, Figure 27) to pivot forward.
5.
6.
Remove the traction drive spring (E, Figure 26).
A
Remove the old traction drive belt (A) from the trac-
tion drive pulley (G) and from the traction drive pulley
(F).  Replace the traction drive belt (A) with an origi-
nal factory replacement belt available from an autho-
rized Dealer.
B
Figure 30. Traction Belt Change
A.  Swing Plate
7.
8.
Install the new traction drive belt (A) onto the traction
drive pulley (G) and onto traction drive pulley (F).
B.  Alignment Tabs
Make sure the traction drive idler pulley (L) is proper-
ly aligned with the traction drive belt (A).
9.
Attach the traction drive spring (E).
10.
Install the swing plate axle rod (I) and secure with the
e-ring (J) removed earlier (E).
11.
The bottom of the swing plate (A, Figure 30) must be
positioned between the alignment tabs (B). Make
sure the swing plate is properly secured.
NOTE: If the drive will not engage after the traction drive
belt has been replaced, then check to make sure that the
swing plate is positioned between the alignment tabs.
12.
Install and adjust the auger drive belt. See Belt
Replacement in this section of the manual.
13.
Adjust the belt guide. See Belt Adjustment in this sec-
tion of the manual.
14.
15.
Install the bottom panel (B, Figure 25).
Tighten the capscrews (A) on each side of the bottom
panel (B).
16.
17.
18.
Reinstall belt cover (A, Figure 21) securing with
screws (B).
Check the adjustment of the cables. See Cable
Adjustment in this section of the manual.
Connect the spark plug wire.
30
Product Specification
CategoriesSimplicity Snow Blower Manuals, Snapper Snow Blower Manuals, Snow Blower Manuals
Tags, , , , , , , , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 36 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandSimplicity, Snow Blower
Document File TypePDF
Publishersimplicitymfg.com
Wikipedia's PageSimplicity Outdoor
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website