Adjusting Drive Belts
If the auger or wheels slip under load, belts could be
stretched or worn. Adjust as follows:
Remove the belt cover (figure 10). Determine which
belt requires adjustment.
\
2.
Loosen the locknut on the appropriate idler pulley
and move the idler pulley toward the belt (figure
Tighten the locknut.
11).
3.
Re-install the belt cover.
Determine if additional adjustment is required by try-
ing the unit. Repeat step 3 if necessary.
auger or wheels continue to after adjust-
ing the idler pulleys, the spring (figure on either con-
trol rod might be stretched and worn and require replace-
ment. Replace either auger control rod spring or
4.
NOTE:
drive control rod spring as necessary, then repeat steps
Adjusting Belt Guides
Check each belt guide for proper clearance using the fol-
11. Drive Belts and Pulleys Belt Cover Off
lowing procedure.
NOTE:
guides on 7 HP mode/s are slight//y different
than shown, but adjustment is the same.
Remove the belt cover (figure
2.
3.
Have someone hold both the auger and drive clutch
levers tight against the handgrips (figure 12).
Loosen the screw securing the belt guide (figure 11).
Adjust the guide so it clears the belt by
The clearance should be equal on both side of the
pulley. Tighten the screw securely.
NOTE: When adjusting the right belt guide, make sure
guide does not contact the
Re-install the belt cover.
hub.
4.
Replacing Drive Belts
The drive belts on this snowthrower are of special con-
struction and should be replaced with original equipment
belts available from your dealer. See COMMON
REPLACEMENT PARTS at the back of
part numbers.
for
Use the following procedure to replace either drive belt.
Figure 12. Drive Control Spring
1.
2.
3.
Remove gas from fuel tank and run engine until it
stops running from lack of fuel.
4.
Loosen the screw securing the belt guide (figure 11).
Pivot the belt guide as necessary and remove the
drive belt from the pulley.
Disconnect spark plug wire and fasten it away from
the spark plug.
5.
Stand the snowthrower up onto the auger end.
Remove belt cover (figure 10).
1
2
| Categories | Simplicity Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Simplicity 1691411, Simplicity 1691413, Simplicity 1691414 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Simplicity, Snow Blower |
| Document File Type | |
| Publisher | simplicitymfg.com |
| Wikipedia's Page | Simplicity Outdoor |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)