WHEEL AXLE BEARING
REPLACEMENT
After approximately 100 hours of use (about 5 years), or
if drive chain jumps off sprockets, wheel axle bearings
may need to be replaced.
1.
2.
3.
4.
Disconnect spark plug wire and fasten it away from
the spark plug.
Place a block under the snowthrower so the wheels
are just off the ground.
See figure 16. Remove the ring pin and wheel from
each axle.
Slide off the washers and long spacer.
A
CAUTION
.
,
Bearing
E-ring
Note the number and placement of washers used
between wheel and long spacer, or between long
spacer and bearing. An even number of washers
must be used on each side of the shaft.
I
Figure 16. Wheel and Auger Bearings
AUGER SHAFT BEARING
REPLACEMENT
5.
Pull bearing out of housing opening and off of the
shaft.
If auger shaft bearings need replacement, proceed as
follows:
6.
Install new bearing by aligning bearing flat sides with
flat sides in housing.
1.
2.
Pry off the E-ring (figure 16).
7.
8.
Install washers and long spacer.
Install wheel and ring pin.
Remove the washers, then pull the bearing out of the
housing and off the shaft.
3.
4.
Install new bearing by aligning bearing flat sides with
flat sides in housing.
Install washers. Install a new E-ring securely in shaft
groove.
1
4
| Categories | Simplicity Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Simplicity 1691411, Simplicity 1691413, Simplicity 1691414 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Simplicity, Snow Blower |
| Document File Type | |
| Publisher | simplicitymfg.com |
| Wikipedia's Page | Simplicity Outdoor |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)