English / USA
Lubricating the
Gearbox
If engine is down on power, difficult to
start or runs poorly at idling speed, first
check the spark plug.
:
Remove spark plug as described
in chapter "Starting / Stopping the
Engine".
2
2
1
:
:
Clean dirty spark plug.
Check the electrode gap (A) and
readjust if necessary – see
"Specifications".
:
Check grease level regularly –
about every 25 hours of operation.
:
Use only resistor type spark plugs
of the approved range.
1
:
:
Unscrew the filler plug (1).
Rectify problems which have caused
fouling of spark plug:
If no grease can be seen on the
inside of the filler plug, screw the
tube of grease (2) – see “Special
Accessories” – into the filler hole.
:
:
:
Too much oil in fuel mix.
Dirty air filter.
:
:
Squeeze up to 1/5 oz (5 g) grease
into the gear housing.
Unfavorable running conditions,
e.g. operating at part load.
To reduce the risk of fire and burn
injury, use only spark plugs
Do not not completely fill the gear
housing with grease.
Fit a new spark plug after approx.
operating hours
100
authorized by STIHL. Always press
spark plug boot (2) snugly onto
terminal (1) of the proper size.
(Note: If terminal has detachable
SAE adapter nut, it must be
Refit the filler plug and tighten it
down firmly.
or earlier if the electrodes are badly
eroded.
attached.) A loose connection
between spark plug boot and
ignition wire connector in the boot
may create arcing that could ignite
combustible fumes and cause a fire.
26
FC 110
| Categories | STIHL Straight Edger Manuals, Straight Edger Manuals |
|---|---|
| Tags | STIHL FC 3110 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Edger |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)