English / USA
Adjusting Cutter Bar Angle
Starting / Stopping
the Engine
The angle of the cutter bar relative to the
shaft can be adjusted to 8 positions
between 0° (straight) and 90° (right
angle).
2
The additional settings increase the
versatility of the unit.
2
3
3
1
Adjusting cutter bar angle
:
:
Shut off the engine.
Full Harness*
Starting the Engine
Pull back the sliding sleeve (1) and
use lever (2) to adjust joint by one or
several holes.
:
:
Put on the full harness (2).
Always follow the starting procedure
outlined in the instruction manual of the
basic power tool or CombiEngine you
are using.
With the power scythe attached,
adjust length of strap until the spring
hook (3) is at the same height as
your right hip.
:
Release the sliding sleeve and
allow pin to engage the quadrant
(3).
:
Place the unit on the ground: It must
rest securely on the machine
Sliding sleeve butts against the
housing when the pin is properly
engaged (after making adjustment).
support and the blade gearbox.
:
On units with an adjustable cutter
bar: Set the cutter bar to the straight
(0°)
position.
*
see "Guide to Using this Manual"
FH
13
| Categories | STIHL Straight Edger Manuals, Straight Edger Manuals |
|---|---|
| Tags | STIHL FH |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Trimmer |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)