English / USA
Removing the mowing head
STIHL AutoCut
: Hold the rotating mowing head
:
Block the output shaft.
5
above the ground – tap it on the
ground once – about 1 1/4"(3 cm)
fresh line is advanced.
STIHL SuperCut 20-2,
STIHL AutoCut 25-2, 30-2,
STIHL TrimCut 30-2,
STIHL PolyCut 20-3
The blade in the deflector trims surplus
line to the correct length – avoid tapping
head more than once at a time.
4
3
:
Unscrew the mowing head
clockwise.
Line feed operates only if both lines
still have a minimum length of
1"
(2.5 cm).
1
STIHL FixCut 25-2
:
Use the combination wrench to
unscrew the mounting nut clockwise
from the output shaft
2
All other mowing heads
Refer to instructions supplied with the
mowing head.
If the mounting nut is too loose, fit a
new one
To reduce the risk of injury, always
shut off the engine before adjusting
the nylon line by hand.
STIHL FixCut 25-2
:
Place the mowing head on the
thrust plate (2)
Adjusting nylon line
STIHL SuperCut
Replacing nylon line or PolyCut
blades
Collar (see arrow) must locate in
mowing head’
s mounting hole
Fresh line is advanced automatically if
remaining line is still min. 2 1/2" (6 cm)
long. The blade in the deflector trims
surplus line to the correct length.
Refer to instructions supplied with the
mowing head.
Push the thrust washer (3) over the
shaft (1) so that it locates against
the base.
:
:
Block the output shaft.
Screw the mounting nut (4) with the
combination wrench (5)
counterclockwise on to the output
shaft and tighten down firmly
Remove the stop pin.
30
FS 130, FS 130 R
| Categories | Blower Vacuum and Sweeper Manuals, STIHL Trimmer Manuals, Trimmer Manuals |
|---|---|
| Tags | STIHL FS 130 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Trimmer |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)