English
Storing the Machine
Checking the Chain
Sprocket
Maintaining and
Sharpening the Saw Chain
For periods of 3 months or longer
N
Disengage the chain brake: Pull the
hand guard toward the front handle.
Cutting effortlessly with a correctly
sharpened chain
N
Drain and clean the fuel tank in a
well ventilated area.
N
Remove the chain sprocket cover,
chain and guide bar.
N
Dispose of fuel properly in
accordance with local
A properly sharpened chain slices
through wood effortlessly and requires
very little feed pressure.
Replace the chain sprocket
environmental requirements.
N
Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
Do not work with a dull or damaged
chain as it will increase the physical
effort required, produce unsatisfactory
results and a higher rate of wear.
N
N
N
N
Remove the saw chain and guide
bar, clean them and spray with
corrosion inhibiting oil.
N
N
Clean the chain.
Check the chain for cracks in the
links and damaged rivets.
Thoroughly clean the machine –
pay special attention to the cylinder
fins and air filter.
N
Replace any damaged or worn
parts of the chain and match the
new parts to the shape and size of
the original parts.
–
–
after using two saw chains or
sooner
If you use a biological chain and bar
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
if the wear marks (arrows) on the
sprocket are deeper than approx.
0.02 in (0.5 mm) since this would
reduce the life of the chain. You can
use a gauge (special accessory) to
check the depth of the wear marks.
It is absolutely essential to comply
with the angles and dimensions
specified below. If the saw chain is
incorrectly sharpened – and in
particular if the depth gauge is set
too low – there is a risk of
Store the machine in a dry, high or
locked location, out of the reach of
children and other unauthorized
persons.
It is best to use two saw chains in
rotation with one sprocket.
increased kickback of the saw,
with resulting risk of injury.
STIHL recommends the use of original
STIHL sprockets to ensure correct
operation of the chain brake.
Have the chain sprocket replaced by a
servicing dealer. STIHL recommends
that you have servicing and repair work
carried out exclusively by an authorized
STIHL servicing dealer.
3/8
The chain pitch (e.g. 3/8") is marked on
the depth gauge end of each cutter.
4
0
MS 192 C
| Categories | Chainsaw Manuals, STIHL Chainsaw Manuals |
|---|---|
| Tags | STIHL MS 192 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Chainsaw |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)