english
Spark Arresting Screen*
in Muffler
Checking the Spark Plug
If engine is down on power, difficult
to start or runs poorly at idling speed,
first check the spark plug.
1
1
:
Remove spark plug - see “Starting /
Stopping the Engine“
1
Clean dirty spark plug.
:
:
Check electrode gap (A) -
it should be 0.5 mm/0.02" -
readjust if necessary.
1
If the engine is down on power, check
the spark arresting screen in the muffler.
:
Use only resistor type spark plugs
of the approved range.
:
:
Allow muffler to cool down.
Take out the screws (1).
Rectify problems which have caused
fouling of spark plug:
:
:
:
Too much oil in fuel mix.
Dirty air filter.
2
2
Unfavorable running conditions,
e.g. operating at part load.
Fit a new spark plug after approx. 100
operating hours or earlier if the
electrodes are badly eroded.
Wrong fuel mix (too much engine oil in
the gasoline), a dirty air filter and
unfavorable running conditions (mostly
at part throttle etc.) affect the condition of
the spark plug. These factors cause
deposits to form on the insulator nose
which may result in trouble in operation.
:
:
Bend back the retaining tabs (2).
Remove the spark arresting
screen (3).
:
:
Clean spark arresting screen.
If screen is damaged or heavily
carbonized, fit a new one.
Refit the spark arresting screen in
the reverse sequence.
*
See "Guide to Using this Manual"
MS 360
45
| Categories | Chainsaw Manuals, STIHL Chainsaw Manuals |
|---|---|
| Tags | STIHL MS 360 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Chainsaw |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)