English / USA
Oil Quantity
Taking Care of Guide Bar
Control *
Chain
type
Pitch
Minimum
groove
depth
2
Picco
Rapid
Rapid
Rapid
3/8“ P
0.20"
(5.0 mm)
0.16"
(4.0 mm)
1
1/4“
3/8“; 0.325“
0.404“
0.24"
(6.0
mm)
3
Different quantities of oil are required for
different bar lengths, types of wood and
cutting techniques.
0.28"
(7.0 mm)
:
Use the adjusting screw (1) (on
underside of machine) to vary the
oil feed rate as required.
E = Ematic position, medium oil flow
rate - turn adjusting screw to "E"
(Ematic position)
If groove depth is less than specified:
Replace the guide bar.
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
:
:
1
3
:
:
To increase oil feed – turn adjusting
:
Turn the bar over –
screw clockwise.
every time you sharpen the chain
and every time you replace the
chain – this helps avoid one-sided
wear, especially at the nose and
underside of the bar.
To reduce oil feed – turn adjusting
screw counter-clockwise.
Your chain must always be wetted
with a film of lubricant.
:
:
Regularly clean
the oil inlet hole (1),
the oilway (2) and
the bar groove (3).
Measure groove depth –
with scale on filing gauge* – in area
used most for cutting.
*
Special accessory
*
see “Guide to Using this Manual”
44
MS 361 C
| Categories | Chainsaw Manuals, STIHL Chainsaw Manuals |
|---|---|
| Tags | STIHL MS 361 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Chainsaw |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)