Yard Machines 611 Snow Blower Owners Manual MTD

To   remove   skid   shoes,   remove   the   four
carriage bolts,  cupped washers  and hex  nuts
which   attach   them   to   the   snow   thrower.
Reassemble  new   skid  shoes  with  the   four
carriage bolts,  cupped washers  (cupped  side
goes against skid shoes) and hex nuts.
Drive
Belt
Rear Auger
Belt
Engine
Pulley
To remove  shave  plate, remove  the carriage
bolts,  cupped  washers  and  hex  nuts  which
attach   it    to   the    snow   thrower   housing.
Reassemble  new  shave  plate,  making  sure
heads of the carriage bolts are  to the inside of
the housing. Tighten securely.
Front
Auger
Belt
Idler
Pulley
BELT REMOVAL AND REPLACEMENT
Engine
Pulley
Idler
WARNING: Remove   the   spark   plug
wire  from  the  spark  plug  and ground.
Drain  gasoline  from   the  fuel  tank,  or
place a  piece of plastic  film underneath
the  gas  cap  to  prevent  gasoline  from
leaking.
Pulley
Figure 26
7.
Unhook  the   support  bracket   spring  from  the
frame.
NOTE: It may  be necessary to  loosen the six  nuts
that connect the frame to the  auger housing to aid in
belt removal.
AUGER BELTS
1.
Remove the plastic belt  cover on the front of the
engine
by
removing
the
two
self-tapping
8.
Lift  the  rear auger  belt  from  the  auger  pulley,
and  slip belt  between  the  support bracket  and
the  auger  pulley.  See  Figure  26.  Repeat  this
step for the front auger belt.
screws. See Figure 25.
9.
Replace  both   auger  drive   belts   by  following
instructions in reverse order.
Friction Wheel
Pin
Assembly
Self-Tapping
Screws
Belt
Cover
Support
Bracket
Figure 25
Frame
2.
3.
4.
5.
Drain  the  gasoline  from  the  snow  thrower,  or
place a piece of plastic under the gas cap.
Tip the  snow thrower  up  and forward  so that  it
rests on the housing.
Gear
Shaft
Auger
Belt
Remove six  self-tapping screws  from the  frame
cover underneath the snow thrower.
Roll the front and  rear auger belts off the engine
pulley. See Figure 26.
NOTE: 5.0 HP model has only one auger belt.
Support
Bracket
Spring
Auger
Pulley
Idler
Spring
Auger
Housing
6.
Unhook the idler  spring from the hex bolt  on the
auger housing. See Figure 27.
Figure 27
16
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandYard Machines, 611, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website