Yard Machines 615 E645E E665E Snow Blower Owners Manual by MTD

ADJUSTING THE SKID SHOES
SECTION 6:  CONTROLS
The space between  the shave plate  and the ground
can be adjusted.
For close  snow removal on  a smooth surface,  raise
the  skid  shoes  into  a  high  position  on  the  auger
housing.
Auger Drive Clutch
Traction Drive Clutch
Use a  middle or lower  position when the  area to be
cleared is uneven. See Figure 13.
Chute Crank
Shift Lever
Figure 14
Low Position
High Position
SHIFT LEVER
Skid
Shoe
(See Figure 14)
Hex  Nuts
The  shift  lever is  located  below  the  handle panel.
The  shift  lever  may  be  moved  into  one  of  seven
positions.   Run   engine   with   throttle   in   the   fast
position.  Use  the  shift  lever  to   determine  ground
speed.
Carriage Bolts
Figure 13
Adjust  skid  shoes  by  loosening the  four  hex  nuts
and carriage bolts and  moving skid shoes to desired
position.
Make certain  the entire bottom  surface of skid  shoe
is against  the ground  to avoid  uneven wear  on  the
skid shoes. Retighten nuts and bolts securely.
Forward—one of  five  speeds. Position  number one
(1)
is  the  slowest. Position  number  five  (5)  is  the
fastest.
Reverse—two  reverse  speeds;  R1  and  R2.  R2  is
the faster reverse speed.
TIRE PRESSURE
AUGER DRIVE CLUTCH
The  tires  are  over  inflated  for  shipping  purposes.
Check  tire  pressure  and  reduce  to  15  to  20  psi.
Refer   to    tire   sidewalls    for   recommended    tire
pressure.
(See Figure 14)
The auger  drive clutch is located  on the left  handle.
Squeeze  the   clutch  grip   to  engage   the   augers.
Release to stop the snow throwing action.
NOTE: If  the  tire   pressure  is  not  equal  in   both
tires, the unit may pull to one side or the other.
TRACTION DRIVE CLUTCH
(See Figure 14)
The  traction   drive  clutch  is   located  on  the   right
handle. Squeeze  the traction drive clutch  to engage
the wheel drive. Release to stop.
CHUTE CRANK
(See Figure 14)
The chute  crank is  located on  left hand  side of  the
snow thrower.
To  change  the direction  in  which  snow  is  thrown,
turn chute crank as follows:
Crank clockwise to discharge to the left.
Crank  counterclockwise  to  discharge  to  the
right.
10
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals
Tags, , , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower, Yard Machines, 615, E645E, E665E, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website